The repeatability of a servo-controlled robot is within _____ mm rather than a fraction of a mm.

What is the principal quantum number of a Q shell?

What time when the voltage across L will be equal to the voltage across R in a series RL transient circuit where E = 24 V, R = 10 Ω and L = 1 H?

What is the hysteresis loss at a frequency of 60 cycles per second of an audio transformer magnetic core which has a maximum flux density of 10,000 gausses? The volume of solid iron of this core is 66.8 cubic cm and the hysteresis coefficient (a constant that depends upon grade and quality of iron) id 5.35 x 10-4.

When two coils of equal inductances are connected in series with coefficient of coupling and their fields in phase, find the total inductance of two coils.

A 2 μF capacitor with initial charge q0 = 100 μC, is connected across a 100 Ω resistor at t = 0. Calculate the time in which the transient voltage across the resistor drops from 40 to 10 V.

What do you call a small D.C generator built into alternators to provide excitation current to field windings?

What is the condition of the diode in a parallel-limiter when the output is developed?

What is the payload of the industrial robot AEA IRb-60?

Which of the following robot is primarily used for machining processes?

The Kuka spot welding robot has how many degrees of freedom?

What system in industrial electronics has the ability to monitor certain variable in the industrial processes, the same can perform self-correcting action?

What is the property of a gyro so that the axis of rotation or spin axis tends to remain in a fixed direction in space if no force is applied to it?

In a series RLC circuit with R= 200Ω L= 0.1 H and C= 5µF, find the transient current after the switch is closed at t=0 applying a 200V source.

A 0.09 µF capacitor is charged to 220V. How long in milliseconds will it discharge to a level of 110V if the discharge resistor has a resistance of 20kΩ?

What are the heavy particles that include the proton and the neutron?

What particles have rest masses ranging down to about 0.1amu?

By definition, what is the individual angular momentum of the neutron proton and electron?

In the hysteresis loop, what do you call the product of the residual magnetic flux and coercive field strength?

Programming of a continuous-path robot is normally carried out by a method called ______ through.

What do you call the strong magnetism that occurs in certain ceramic compounds such as ferrites?

What characteristic is determined by the time required for a voltage wave to travel from the input end of an electrical transmission line to the output end and back again?

A disturbance similar to brownout but of shorter duration that occurs when the line voltage drops below 80-85% of its rated voltage by one or more cycles.

What term is given to the positions of the rotors of a synchro transmitter and the synchro receiver when both rotors are on a 0 degree displaced from 0 degree by the same angle?

What ac voltage defect refers to a high voltage (up to 6000V or more) peak lasting approximately 100µs to one-half cycle?

The largest computers commonly use a word size of ______ bits.

What do you call the ratio of the safe load to the nameplate load of an electrical motor?

Covalent bond energy in germanium is about ____ eV.

The service factors of motors vary from ____ to _____.

How many voltage are available from two-phase, three wire alternator?

At what frequency does the RC circuit of an amplifier reduce the voltage gain to 70.7 percent of its midrange value?

What is the operating temperature of class A motor under motor classification?

What particular motor class in which the operating temperature is 180°C?

What are the basic components of a harmonic drive used in robot transmission system?

What is the operating temperature of class B motor?

What is the width of the pulse radiated by a fire control tracking radar?

If the operating temperature is 155°C then it falls under what motor classification?

How much percent is stray losses in dc machines?

What are considered standard minimum distance between components on a chip?

For an advanced chip, the minimum distance between components is

What are used to apply or remove power and to select a function or a circuit within a device?

What do you call a register on the CPU used for the temporary storage of data during arithmetic or logic operations?

What parameter specifies the value of voltage from cathode to cathode at which the SCR breaks into the avalanches region and begins to conduct heavily as in the pn junction diode?

What type of servo system based on the same principle of error-signal generation where velocity is sensed, and the load is moving at the desired velocity?

What is the term for the switch that disconnects the circuit completely at one position before the connection of the next position made?

What is the identifying feature of a colpitts oscillator?

What instrument is used to measure the amount of active ingredients in the electrolyte of a battery?

What is the typical frequency range about the center frequency of a tunable magnetron?

What is a gaseous tube that uses a poll of liquid mercury at its cathode?