NEW
Font size
WorksheetsELECTRONICS - II - FILTERS
Total questions: 15
Worksheet time: 8mins
-------------------- is a circuit which can be designed to modify , reshape or reject all undesired frequencies .
Filter
oscillator
Amplifier
Rectifier
The electronic filter is usually a frequency selective network that passes a specify band of frequencies and ----------------- signals of frequencies outside this band
Allow
Block
What are filters created by using resistors and capacitors or inductors and capacitors called
Active filter
Passive filter
Differential filter
All pass filter
What kind of filter is shown in the figure ?
Low Pass Filter
High Pass Filter
Band pass filter
Notch filter and band stop filter are same ?
True
False
A low pass filter is
Passes the frequencies lower than the specified cut off frequency
Rejects Lower frequencies
allows the higher frequencies
All of the above
High pass filter is
Passes the frequencies higher than the specified cut off frequency
Rejects higher frequencies
allows the lower frequency
All the above
•a band stop between two cut off frequencies fc2 and fc1 and two pass bands :
•0<f<fc1 and f>fc2 .
True
False
A Circuit that uses an amplifier with passive filter elements is called as
Oscillator
Signal Generator
Active Filter
Differential Amplifier
Plotting graph between Gain and frequency
Frequency Response
Time Response
Amplitude Response
Active filters are usually fabricated by
R
RC
RLC
OP -AMP
The gain of the 1st order low pass filter decay rate is
30 db/decade
50 db/decade
40 db/decade
20 db/decade
A ________ filter rejects all frequencies within a specified band and passes all those outside this band.
Low pass
High pass
Band pass
Band Stop
A ________ filter significantly attenuates all frequencies below fc and passes all frequencies above fc.
Low pass
High Pass
Band Pass
Band Stop
The critical frequency is defined as the point at which the response drops ________ from the passband.
- 3 db
-20 db
-6 db
- 40 db
