wayground logo

Free Printable Worksheets

NEW

Font size

S
M
L
XL
Worksheets

971902 Audi Electronic Diagnosis Quiz 2

Total questions: 16

Worksheet time: 8mins

Name
Class
Date
1.

Which data bus system of the 2019 A6, A7 and A8 is capable of operating (properly) in single wire mode?

a)

Powertrain CAN

b)

Convenience CAN

c)

LIN bus

d)

Both the Powertrain CAN and Convenience CAN

2.

What is the purpose of the shunt resistor in the J367 Battery Monitoring Control Module?

a)

Measuring battery temperature

b)

Measuring charge and discharge current of the battery

c)

Sending and receiving LIN signals to J533

d)

All of the above

3.

When talking about a pulse-width modulated signal that has a total period length of 10ms. If there is an on time length of 3ms, what is the duty cycle of the signal?

a)

70%

b)

3%

c)

10%

d)

30%

4.

What is important to know when checking power supply of a control module using measuring value blocks?

a)

The scan-tool sampling rate is too low and the DSO should always be used

b)

Measuring value blocks always show the peak voltage of a control module

c)

Control modules often have several power supplies, which cannot all be tested via MVBs

d)

You cannot read voltage readings in MVBs

5.

When the temperature increases, the resistance of an NTC (temp. sensor)...

a)

Decreases

b)

Increases

c)

Decreases until the sensor reaches 45 degrees Celsius and then increases

d)

Does not decreases or increases because it works on Hall principals

6.

DIN standard terminal 31 can be best described as...

a)

Battery positive

b)

Chassis ground

c)

Load reduction

d)

Switched power

7.

When looking at the below MVB data string for static current shortfalls. What does the "01" represent?122*2019-03-26-15:13*00.5*01*00000

a)

Number of terminal 15 cycles

b)

Number of total static current shortfalls

c)

Running battery number

d)

Time of static current shortfalls in hours

8.

Coaxial cables are used in all of the following except...

a)

J533 communication

b)

AM/FM antennas

c)

GPS antennas

d)

Rear view cameras

9.

You can pair and switch between two phones in the MMI system

a)

True

b)

False

10.

Which of the following are control module functions?

a)

Basic settings

b)

Read measure value blocks

c)

Replace control module

d)

All of the above

11.

The J1122 Laser Distance Regulation Control Module communicates over what type of bus?

a)

High speed CAN

b)

Low speed CAN

c)

FlexRay bus

d)

MOST bus

12.

Long-range radar of the Adaptive Cruise Control Module J428 has an approximate range of...

a)

147 yards

b)

273 yards

c)

500 yards

d)

0.5 mile

13.

Intersection Assist is active at approximately what speed range?

a)

18 - 38 mph

b)

Up to 30 mph

c)

Any speed range

d)

0 - 18 mph

14.

When looking at the below MVB data string for static current shortfalls. What does the "122" represent?122*2019-03-26-15:13*00.5*01*00000

a)

Number of terminal 15 cycles

b)

Number of total static current shortfalls

c)

Running battery number

d)

Time of static current shortfalls in hours

15.

When looking at the "shut off stages history" battery data string below, what is the current State of Charge (SOC) percentage? 098*2019-02-19-18:02*1*0*0*060*016*0000*0*00.0*00.0

a)

60%

b)

98%

c)

16%

d)

20.19%

16.

When looking at the "static current exceeding" battery data string below, how many times has the battery been replaced? 120*2019-03-26-13:30*0001.0*027*00141*0000*02*00001

a)

Never

b)

Once

c)

Twice

d)

27 times