An engineered material created through a patented procedure that bonds glossy porcelain-enameled metal to a structural composite through an injection moulding process, used in manufacturing bathtubs. What is the designated name of this patented material used in market today?

Which type of pump is commonly used to convey or remove storm or underground water from a pit?

The unit is submerged under water with the discharged connected above it and into the drain located at the street level.

What kind of plastic fitting can be used to connect galvanized iron pipe to a plastic pipe directly without the use of coupling?

When designing a septic tank, which of the following practices is NOT acceptable in so far as standard trade practice and code requirement is concerned?

In waste disposal system, one of the concerns of sanitary engineers and public health officials is the spread of disease caused by bacteria found in sewage. What type of bacteria are present in feces excreted by man and animals?

What material has that property that allows the smooth flow of wastewater due to its low flow resistance?

What kind of joint which utilizes heat as a means of bonding monolithically plastic pipes and fittings of homogenous composition?

The following are examples of drainage fittings EXCEPT ______

Which among the following classes of galvanized steel pipes has the thickest wall section?

Which of the following items is considered a fixture?

Which of the following conditions may cause backflow?

In the abbreviations PEx, what does x stand for?

Which of the ff. Paramters or factors can be used to size drainage pipes?

Which of the following fixture combination can be technically considered a battery of fixture?

Using the rule of thumb in the design of a septic tank with a digestive chamber capacity of 4 cubic meters,

What should be the liquid capacity of the leaching chamber?

Pipes used in the plumbing industry are provided by manufacturers. The manufacturing of pipes is based on standards set by authorities and trade consultants.

Which of the following sizes is not commercially available, hence, pipes of this size are commonly substituted with a larger one?

A check valve is a kind of backflow prevention device used in what system of plumbing?

A globe valve is a kind of valve in which the flow of water is cut off by means of circular disk that fits against the valve seat. What is the appropriate position or direction of liquid flow inside the valve based on the given figure below?

Vent Pipes should be installed in plumbing system in order to prevent ________

What design provision should be critically considered in the design and construction of a septic tank?

Which in the list is a term NOT aptly used in sanitary drainage system?

Which of the following would logically have the least pipe size?

A stack is approximately applicable to a vertical line of _______

A yoke is a type of ventilation used as an interconnection between what sections or portions of plumbing systems?

Which of the following type of ventilation is used to provide air circulation for two traps placed back to back or side by side such as lavatories or urinals?

The term impedance is used in transformers and other devices in ac system is a combination of _______

Mho is defined as ______

Copper as a conductor has the property or properties of being ________

Cables are conductors that are ______

A factory assembly of one or more conductors, each individually insulated and enclosed In a metallic sheath of interlocking, metal tape or a smooth corrugated metallic tube.

Fusible material in a fuse may be made of any of the following except _______

A type of switch used for transferring one or more load conductor connections from one power source to another

The following are components of a Fan Coil Unit (FCU) except ________

Which refrigerant type is commonly used in split type air conditioning?

What part of the air conditioning system pulls the air from intake through filters and distributes it to the conditioned space?