NEW
Font size
WorksheetsDrilling, Taps & Dies, Reaming
Total questions: 21
Worksheet time: 11mins
Power from the motor of the sensitive drill press is transmitted to the ___________through the belt drives.
Spindle
Headstock
Head
None of these
Which following type of drill press is used to drill very large pieces?
Microdrill press
Sensitive drill press
Magnetic based drilling machine
Radial arm drill press
Two types of twist drills are?
Straight Shank, Taper Shank
Taper Shank, Countersink
Flat drill, Slocombe
Centre drill, Countersink
The depth to which the drill will advance in the work is controlled by the
Dept micrometer
Rack and pinion
Spindle
Depth Stop
The point angle for a general purpose twist drill is ____.
90 degrees
118 degrees
130 degrees
140 degrees
What is the name of the cutting tool used in the drilling process?
Drill holder
Drill bit
Steel bit
Knife
The type of drilling machine shown in figure is called:
Bench drilling machine
Hand drilling machine
Up- right drilling machine
Radial Arm drilling machine
The type of drilling machine shown in figure is called:
Bench drilling machine
Hand drilling machine
Up- right drilling machine
Radial Arm drilling machine
twist Drill Holding method shown in figure is called:
Angle plate
Machine vice
sleeves
Drill chuck
Which method used for holding twist drill shown in figure?
vice
Direct holding
sleeves
Spindle
The work piece holding method shown in figure is called.
Angle Plate
Strap Clamps
V-Blocks
Machine vise
The work piece holding method shown in figure is called.
Machine vise
V-Blocks
Strap Clamps
Angle Plate
The work piece holding method shown in figure is called.
Strap Clamps
V-Blocks
Angle Plate
Machine vise
The tool shown in figure is
reamer
Twist drill
tap
counter borer
counter boring
countersinking
drilling
Reaming
The following tool is used for __________
tapping operation
reaming operation
drilling operation
cutting operation
This is a ...
stamp
clamp
bump
lump
What is the formula for calculating the drill
size for reaming?
Drill size=Reamed size-(Under size-over
size)
Drill size=Reamed size+ (Under size + over
size)
Drill size=Reamed size-(Under size +over
size)
Drill size=Reamed size-(Under size x over
size)
Which is used to hold the die?
Wrench
Spanner
Stock
Chuck
What is the uses of hand tap?
To make external thread
To make internal thread
To bevel at the hole end
To make enlarge hole
