WorksheetsTopographical Map Set 1
Total questions: 75
Worksheet time: 43mins
A contour interval is the
difference in distance between one contact line and the next
difference in color between one contour line and the next
difference in elevation between one contour line and the next
_______________ is a 2-D map that shows the elevation and elevation changes of the land in an area.
contour lines
relief
topographic map
elevation
______________________ are lines that connect areas of the same elevation and eventually form a closed loop.
contour lines
parallel lines
intersecting lines
relief lines
The closer the contour lines are together, the ______________ the slope.
thinner
wider
flatter
steeper
What is a topographical map?
A map that shows the state and national boundaries of a place.
A map that shows the information about the climate of different areas.
A map that shows detailed, accurate physical and human graphic representation of features that appear on the Earth's surface.
A map that shows the different resources present in the area or the economic activity prevalent.
4°×4° sheets are called
Million sheets
Quarter sheets
Quadrant sheets
The extent of each Quarter sheet is
1°×1° sheets
2°×2° sheets
4°×4° sheets
3°×3° sheets
15'×15'sheets are called
Quarter sheet
Million sheets
Quadrant sheets
L S Sheet
This is symbol for ?
Bridge
Building
School
Helipad
A CONICAL HILL IS SHOWN BY ....... CONTOURS
Widely spaced
Closely spaced
Concentric
Elliptical
Two hills separared by a gap or a pass
Saddle
Ridge
Cliff
Range
If a relief is cut vertically along a strait line,then the side view of the cut is called
Side section
Profile
Down section
Image
A low lying area between two hills or ridges,often occupied by a river
Plateau
A valley
Plain
Desert
A slope shown by irregularly spaced contours
Steep slope
UNDULATING slope
UNIFORM SLOPE
concave slope
The exact height of a spot or a place above the mean sea level ,as shown on a toposheet
Bench mark
Height
Spot height
Place height
Bench mark on a toposheet is identified as
Black dot followed by BM and a number
Black dot and BM
Black dot and the number
Black dot and the height
Match the topographic map to its profile.
Match the topographic map to its profile picture.
Which one of the following codes given below correctly represented in SOI toposheet using Line symbol?
(a) Bench Mark
(b) Contour
(c) Spot height
(d) Triangulation station
a, b and c
a, c and d
b and c
b only
From a contour map if a gradient of 1 in 30 was calculated between any two points, it would be equivalent to a slope of-
1⁰
2⁰
3⁰
4⁰
which one of the following areal extent is represented by an area bounded by a squareof 3 cm ₓ 3 cm on a 1:50,000 scale topographical sheet?
9.00 sq km
1.00 sq km
3.20 sq km
2.25 sq km
The contour interval followed in SOI Toposheet with 1:25,000 scale is-
10 Meters
20 Meters
50 Meters
100 Meters
Match List I with List II and select a correct answer using the codes given below-
List I (Topo Map Scale)
1. Million
2. Quadrant
3. Quarter Inch
4. Half Inch
List II (Contour Interval in meter)
(a) 50
(b) 500
(c) 100
(d) 20
Codes:
(A) a-4, b-1, c-3, d-2
(B) a-1, b-2, c-3, d-4
(C) a-1, b-4, c-3, d-2
(D) a-2, b-3, c-4, d-1
A
B
C
D
Consider the following statements and chose the correct answer from the codes given:
(A) The contours which represent a convex slope are close together at the foot and are comparatively farther apart at the top.
(B) The closeness of contours indicate steepness of slope.
Codes:
A) Both (A) and (B) are true
B) Neither (A) nor (B) are true
C) Only (A) is true
D) Only (B) is true
A
B
C
D
The heights of individual points on topographical maps are indicated by-
Spot height only
Benchmark only
Triangulation point only
All of the above
Total Number of million sheet (Old series map) covering the Indian subcontinent is -
37
38
39
40
Total Number of million sheet (Open series map) covering the Indian subcontinent is -
30
31
32
33
Among which is the correct RF scale of LS (Large Scale) topographical Sheet-
1:2000
1:10000
1:25000
1:50000
Among which is the correct RF scale of F45D11Y topographical Sheet-
1:2000
1:10000
1:25000
1:50000
Among which is the correct RF scale of G47D16NW topographical Sheet-
1:2000
1:10000
1:25000
1:50000
The actual heights of places above the sea level are shown by-
contours
spot heights
hachures
hill shading
The topographical map of India are published by -
Government of India
Geographical Survey of India
Survey of India
Geological Survey of India
The contours intersect each other in case of a/an-
overhanging cliff
escarpment
conical hill
undulating slope
The contour showing a /an _______come very close to or meet each other but do not intersect each other.
vertical cliff
river
conical hill
uniform slope
Contours drawn at a uniform distance indicate a
gentle slope
steep slope
uniform slope
convex slope
What is indicated by contours drawn increasingly closer as the height increases?
gentle slope
steep slope
uniform slope
convex slope
What is indicated by closed (circular) contours with decreasing height towards the centre?
river valley
conical hill
glacial valley
crater lake
Dots marked on maps with a number indicating its altitude are called-
hachures
bench marks
spot heights
trigonometrical stations
The bench marks is/are-
an actual point on the ground with measured height and represented by symbol B.M.
actual point on the ground with known height and shown on maps as small triangles
a point on the ground with known height used during the triangulation survey
a representative of the sea level surface
By what colour are the contours shown on topographical maps?
blue
green
brown
black
The hachures are
broken lines showing the direction and degree of slope
broken lines showing the altitude on maps
solid brown lines showing altitude on maps
circles drawn on maps to show relief
A uniform but steep slope is shown by
close but equi-spaced contours
sparse but equi-spaced contours
closely spaced contours in pairs
form lines and hachures
Which of the following represents the steepest gradient?
1:200
1:50
1:100
1:20
The term 'local relief' of an area implies the
Altitude of the highest point in the area
Average height of the area above sea level
Altitude of the lowest point in the area
Difference between the highest and the lowest points in the area
A hypsometric curve shows the
proportion of area above a given datum level
Places having the same altitude
Total area above a given datum level
amount of evapotranspiration
Isopleth of altitude are called------
isotims
isochrones
isohypses
isobaths
The gradient can be defined as the-
height above sea level
difference between the highest and the lowest points
decline in height per unit of horizontal distance
decline in height per unit of vertical distance
The contour interpolation implies-
drawing of contours on the basis of known heights of same points
drawing of contours at a greater interval
replacing contours by form lines and hachures
reconfirmation of contours on the basis of new data
Which profile of a river will suit for showing a waterfall?
Longitudinal profile
Cross profile
Both of them
none of them
Intervisibility of two points can be khown with the help of a contour map by-
drawing a profile of the area
a simple study of the contour alignments
converting it into a block diagram
it cannot be done with only a contour map
What is indicated by the contours as shown in Figure
Convex slope
Concave slope
Plateau
Undulating slope
What is indicated by the contours as shown in Figure
conical hill
Cliff
Spur
Undulating slope
What is indicated by the contours as shown in Figure
A waterfall
Uniform slope
Convex slope
A cirque
What is indicated by the contours as shown in Figure
Conical hill
Plateau
Uniform slope
Volcano
What is indicated by the contours as shown in Figure
Conical hill
cirque
undulating slope
spur
The three profile shown in diagram X, Y and Z represent respectively-
Projected, Composite and Superimposed
Superimposed, Projected and Composite
Composite Superimposed and Projected
Superimposed, Composite and Projected
Match List I with List II and select a correct answer using the codes given below-
List I (Index No. of Indian Toposheets)
a. 64
b. 64 M
c. 64 M/NE
d. 64 M/10
List II (Identified as per scale)
1. One Inch Sheet or Quadrant Sheet
2. Million Sheet or 1 M Sheet
3. Quarter Inch Sheet or Degree Sheet
4. Half Inch Sheet or Half degree sheet
Codes:
(A) a-2, b-3, c-4, d-1
(B) a-1, b-2, c-3, d-4
(C) a-1, b-4, c-3, d-2
(D) a-2, b-3, c-4, d-1
A
B
C
D
The three profile shown in diagram X, Y and Z represent respectively-
Projected, Composite and Superimposed
Superimposed, Projected and Composite
Composite Superimposed and Projected
Superimposed, Composite and Projected
The scale of the one-inch Indian toposheet converted into metric system is now given as
1:5000
1:25000
1:50000
1:250000
The form lines are
the interpolated contours
the extrapolation of contours
Significant contours
Generalized contours
Match List I with List II and select a correct answer using the codes given below-
List I (See the diagram)
1. See the diagram
2. See the diagram
3. See the diagram
4. See the diagram
List II (Drainage Patterns)
(a) Rectangular
(b) Radial
(c) Annular
(d) Trellis
Codes:
(A) a-4, b-1, c-3, d-2
(B) a-1, b-2, c-3, d-4
(C) a-1, b-4, c-3, d-2
(D) a-2, b-3, c-4, d-1
A
B
C
D
Each 1 : Million series (India and adjacent countries) topographical sheet contains sixteen 1 : 250000 sheets and each 1 : 250000 sheet contains sixteen 1: 50000 sheets. How many 1:25000 (7ʹ30ʹʹΧ7ʹ30ʹʹ) sheets are contained in each 1:50000 sheet?
2
4
8
16
Among which profile illustrates the ruggedness of the skyline?
Serial profile
Superimposed profile
Projected profile
Composite profile
Among which profile illustrates the panoramic view of landmasses?
Serial profile
Superimposed profile
Projected profile
Composite profile
The vertical lines in a topographical map is called
Longitude
Eastings
Northings
Horizontal lines in a topographical map are called
Latitudes
Northings
Longitudes
Topographical maps are published in 1767 by
Survey of India
Survey of America
Survey of India in Dehradun
Survey of Africa
INCA Founded on __________ at Hyderabad, the Indian National Cartographic Association (INCA) has evolved into one of the biggest organizations of its kind in the world. From a modest beginning with 79 members on its role initially, today it is a professional body with around 3000 Life Members and 84 Institutional Life Members. It has Branches functioning at Bangalore, Bombay, Calcutta, Chandigarh, Dehra Dun, Delhi, Gujarat, Hyderabad, Indore, Jodhpur, Kerala, Orissa and Tamilnadu.
7th August, 1979
17th August, 1979
27th August, 1979
2nd August, 1979
____ is an instrument used to measure distances along curved lines.
Anemometer
Hygrometer
Opisometer
Barometer
Which of the following is denoted by red colour on a topographical sheet?
Stony wasteland
Settlement
Railway line
Orchard
