True or False, when clamping your work to the table you should always clamp on the feed lever side of the table.

The function of the depth stop is to _______.

True or False, the scrap board on top of the table is to protect the table from being drilled into and to help with splintering on the under side of your project.

When drilling large holes or using a larger bit, one should ______.

Make sure that the drill press has a start/stop button within easy reach of the operator.

2. What personal protective equipment should be used when operating a drill presses?

You should never use your hands to remove metal cuttings from the drill press table. Instead you should use a:

Drill press training is only required if I have no previous experience using a drill press.

When you finish using the drill press, you can leave the drill bit in the machine, someone else may need it too.

Small drill bits run at a ______ speed

The band saw blade always cuts:

The upper blade guard should be:

If a band saw breaks or slips off, you should.

When backing out of a long cut, you should:

Students should always do this when using the band saw:

The minimal distance your fingers should be from the blade is:

What should you never do while the saw is on:

Make several Relief cuts before cutting tight curves

You need the Instructors ___________________ to use the router.

1. Before using the router check for any apparent ___________ to the table or router

1. You should always __________ the router before making any type of adjustments or cutter bit changes.

1. The instructor must _____________ all adjustments before you turn the power on.

1. Hold the material ___________ whenever the power is turned on, be sure the router switch is in the off position before you unplug

1. Use only the __________ wrenches when you change bits, cutters, or attachments

1. Keep ________ __________ on the router whenever it is in use

Router cuts are made with a ________&__________ movement.

1. When you finish the cutting operation, the first thing you should do is turn the power ______.

1. The cutter must ______ __________ the material you plan to rout before the power is turned on.

1. When using a router, protect your eyes from flying chips and/or pieces of broken cutting bits by wearing approved _____ protection

Safety glasses must be worn any time you are working, watching someone else work, or are near any running machines.

Where should the material being sanded be held if the disc sander rotates counterclockwise?

Which sander is used to sand the inside of curved cutouts?

Long hair must be tied back and loose clothing must be taken off before operating any machines.

When using any sanding machine students must _________________________________________________.

What might happen if you sand on the wrong side of the disc sander?

You should always keep your material slightly moving side to side while using any of the sanding machines.

When using the spindle sander always

While operating the belt/disc sander____________________.

The material is to be held firmly in both hands as the sanding operation is being performed on all sanding machines.