wayground logo

Free Printable Worksheets

NEW

Font size

S
M
L
XL
Worksheets

IMI auto AE06 Electrical Diagnostics

Total questions: 36

Worksheet time: 36mins

Name
Class
Date
1.

On a hybrid vehicle, which one of the following is responsible for the amount of regenerative braking required?

a)

The main brake pedal switch

b)

The ABS modulator valves

c)

Master cylinder pressure sensor

d)

All four wheel speed sensors

2.

What does a central door locking actuator contain?

a)

Solenoid and rocker switch

b)

Drive motor and gear

c)

Motor and solenoid

d)

Solenoid and gear

3.

What is the name of the electrical principle, that is used to stop the wiper system against momentum, once the wipers has been switched off?

a)

Regenerative braking

b)

Electromotive force

c)

Electromagnetic induction

d)

Reactive braking

4.

The device shown is more commonly know as

a)

a logic gate

b)

a transistor

c)

a solenoid switch

d)

an intergrated circuit (IC)

5.

How is the compressor clutch engaged on an air conditioning system?

a)

Using a solenoid

b)

Using Permanet magnets

c)

Electromagnetically

d)

Mechanically using gears

6.

What should the resistance reading of a door contact switch be, when the door is closed?

a)

Infinity

b)

0 Ohms

c)

100 Ohms

d)

10K ohms

7.

What are the main advantages of using LED lighting

a)

They produce a bright blue light from 1 LED

b)

Quick reaction and greater reliability

c)

Quick reaction and greater reliability

d)

Slow reaction time increasing life expectancy

8.

On a typical vehicle heater system, a customer complains of loss of slowspeeds of the motor. What would be the most likely fault?

a)

Resistor pack failure

b)

Coolant sensor faulty

c)

Switch faulty unit

d)

Motor brush failure

9.

When checking an electric window or mirror, what should be checked first?

a)

Fuse

b)

Switch

c)

wiring

d)

Motor

10.

In relation to cooling and air conditioning, what is meant by the term convection?

a)

Transfer of heat using waves or particles

b)

The difference in air pressure

c)

Transfer of heat which involves a fluid

d)

Flow of heat through a material

11.

On a SRS system with an Airbag and Seatbelt Pre-tensioner, what will be occurring from 10-15 milliseconds after impact?

a)

Driver hits the bag and the pre-tensioner releases

b)

Impact identified and pre-tensioner ignition

c)

Airbag is inflated and the pre-tensioning is complete

d)

Airbag starts to inflate and pre-tensioner moving

12.

What would the symptom be, if the system earth failed on an electric window circuit?

a)

Window would opeerate slowly

b)

Window would not operate

c)

Window would only do down

d)

Window would only go up

13.

What does PWM stand for?

a)

pulse width modulation

b)

primary wired modules

c)

Pulse weighted motors

d)

Pulse wired motors

14.

How many motors are used in a typical single electric mirror adjusting system?

a)

1

b)

2

c)

3

d)

0

15.

which one of the following terms applies to the reflector part of a headlight?

a)

Prism

b)

lense

c)

Parabolic

d)

condenser

16.

What are the symptoms likely to be the next time the engine is started if the alternator charge warning lamp has blown?

a)

The alternator will overcharge

b)

The alternator will only charge at idle

c)

The alternator will only charge at high revs

d)

The alternator will not charge

17.

The pattern shown on an oscilloscope of an hall effect type sensor would be a

a)

Square wave

b)

cosine wave

c)

saw tooth

d)

Sine Wave

18.

How does an ABS system with an inductive wheel speed sensors know that a wheel is slowing down?

a)

an decreasing D.C. voltage

b)

an increasing D.C. voltage

c)

an decreasing A.C. voltage

d)

an increasing A.C. voltage

19.

the diagram represents a wave form from an inductive speed sensor. What will happen to the sine wave as the component rotates faster?

a)

Voltage remains the same and the frequency increases

b)

Voltage increases and the frequency increases

c)

Voltage increases and the frequency remains the same

d)

voltage remains the same and the frequency remains the same

20.

What is an electronic device that lets electronic current flow only 1 way

a)

zener diode

b)

capacitor

c)

Transistor

d)

Rectifier

21.

Your Satellite Navigation system is struggling to locate your position. the most likely cause is

a)

a faulty yaw angle sensor

b)

a faulty wheel speed sensor

c)

only 2 satellites are in view of the receiver

d)

only 3 satellites are in view of the receiver

22.

What will be the effect of a lamp with a poor earth connection?

a)

Lamp will be dim

b)

Circuit fuse will blow

c)

the bulb will blow

d)

lamp will be brighter

23.

An ohms test on a Thermister indicates 0C=4500 ohms 100C 200 ohms this type of thermister is

a)

negative temperature coefficient

b)

positive temperature coefficient

c)

exponential temperature coefficient

d)

reverse temperature coefficient

24.

The pattern shown on an oscilloscope of an inductive type sensor would be a

a)

square wave

b)

cosine wave

c)

saw tooth

d)

sine wave

25.

The function of the low pressure switch in an air conditioning system is to

a)

regulate refrigerant flow when the system is switched on

b)

increase air flow through the condenser when required

c)

disconnect the compressor due to low gas/liquid level

d)

reduce evaporator temperature when required

26.

What is a multiplex network?

a)

a data bus system carrying signals to and from remote control units

b)

more wiring than conventional automotive wiring systems

c)

a data bus system carrying battery voltage to and from remote control units

d)

a data bus system carrying AC signals to and from remote control units

27.

What readings would be expected when checking the feed to the terminals on a front heated screen?

a)

Within 0.5v of the battery voltage

b)

Within 1.75V of the battery voltage

c)

Within 2.5v of the battery voltage

d)

Within 4.6v of the battery voltage

28.

What is the correct procedure to check for a parasitic drain

a)

Ignition off, disconnect both battery leads and connect an ammeter in parallel

b)

Ignition off, disconnect the battery earth and connect an ammeter in series

c)

Ignition off, disconnect the battery positive and connect a voltmeter on series

d)

Ignition on, disconnect both battery positive and connect an ohmmeter in series

29.

A diesel glow plug is suspected to be faulty. The test to be carried out would be

a)

an amperage check with an ohmmeter

b)

a switching check with an oscilloscope

c)

a voltage check with an ohmmeter

d)

a resistance test with an ohmmeter

30.

What on a car uses a sun load sensor?

a)

Climate control system

b)

Central door locking

c)

A car alarm

d)

An electric window

31.

A gas discharge bulb contains what

a)

electrodes, argon, silver and metal salts

b)

electrodes, xenon, mercury and metal salts

c)

wire elements, helium gas and metal salts

d)

a tungsten electrode, silver and metal salts

32.

What does Flemings left hand rule relate too?

a)

Flemings right hand rule is used with motors

b)

Flemings left hand rule is used with generators

c)

Flemings left hand rule is used with motors

d)

Flemings left hand rule is used with ohms law

33.

On a hybrid electric vehicle, regenerative braking is when the

a)

generator acts as a motor

b)

brake fluid recuperates

c)

parking brake is slowly applied

d)

motor acts as a generator

34.

Which of the following statements is correct?

a)

1 Hertz = 1 cycle per second

b)

Hertz is the unit of magnetic flux

c)

The unit of power is the Hertz

d)

1 Hertz = 360 degrees rotation

35.

When checking for parasitic drain, the voltmeter is connected in parrallel with the battery and all consumers are switch on

a)

True

b)

False

36.

A strain gauge pressure sensor incorporates the use of

a)

magnetic induction

b)

a thermister

c)

sensing resistors

d)

piezo crystals