WorksheetsFundamentals Week 8.2
Total questions: 15
Worksheet time: 13mins
Another Name for Engine Hoist:
Overhead Lift
A-Frame
Cherry Picker
Overhead Sling
The Gravitizer
Match the following
A-Frame Hoist
Engine Hoist
Jack Stand
Transmission Jack
My Dad Hates These
Match the following
Seed
Pit
Service Pit
Arm Pit
Brad
Whats the name of the tool used to loosen or tighten the drill around a bit.?
Key
Chuck
Rabbit
Toothed Handle
Beaver
Tech A says: When using a Die... The side with the numbers should be facing outward after installing it in the Die Wrench. Tech B says: The Die should be the same size as the bolt being cut. Who is correct?
Tech A
Tech B
Both Tech A and B
Neither Tech A nor B
Tech A says: when drilling in metal its best to use the drill at full speed. Tech B says: Even if the drill bit is cutting into the metal, its best to use some lubrication to prevent the bit from overheating. Who is Correct?
Only Tech A is correct
Only Tech B is correct
Both Tech A and Tech B are correct
Neither Tech A nor Tech B are correct
Match the Following:
Drill Press
Hydraulic Press
Bench Press
French Press
Fake Press
Match the following
Tap Wrench
Die Wrench
Needs a Chuck
Doesn't need a Chuck
Just Chuck
TTY:
(a)
Describes the amount of twisting force allowable for a fastener for a specification showing the twisting force from an engine crankshaft , supplied by the manufacturers.
Torque Spec
Dyno Rating
Horsepower
Brake Horsepower
Tor Limit
Electric/Hydraulic Press Can be capible of ______ tons or more of pressure:
10-15
20 - 40
30 - 50
30 - 60
40-75
What is this:?
Bottle Jack
Transmission Jack
Floor Jack
Pneumatic Jack
Scissor Jack
Another name for a Chain Hoist:
(a)
An automotive lift is not a crane, a jack, or a _________
Mechanical Ladder
Platform
Jackstand
Hoist
Lunch Table
Never use hoist for lifting loads heavier than allowed by the (a) .
