Which of the following follows the Carnot theorem?

Which of the following is chosen as the standard thermometric substance?

Heat flow into a system is ____, and heat flow out of the system is ________

In which of the following systems does mass transfer occur across the system boundary?

When more than one fluid stream enters or leaves the control volume, which of the following type of balance is taken?

The entropy of an isolated system can never ____

The enthalpy and internal energy are the function of temperature for______

Joule was the first to prove that heat is a type of energy, laying the groundwork for the fundamental law of thermodynamics.

Which of the following type of motion does Shaft uses to do work?

What is fluid mechanics?

Principle of fluid mechanics works on the utilization of________

Which of the following is a type of fluid based on viscosity?

Pressure variation for compressible fluid is maximum for which of the following kind of process?

Which among the following is not global parameters of fluid?

Which among the following have the same forces acting on them?

Which of the following equation must be perfunctorily satisfied while dealing with fluid flow problems?

Which of the following is the mathematical technique used to predict physical parameters?

Which among the following is referred to as the temperature at a stagnation point in the flow of fluids in fluid mechanics and thermodynamics.

. Stagnation point is the point in fluid mechanics where the velocity of the fluid at that point is _____

Which of the following is used to produce quality screw threads?

. In surface finishing operation one should use a sharp tool with a ______ feed and _______ Speed of rotation of the job.

. Which of the following is correct about series of range of speed in simple lathe?

In which of the following, tail stock method of taper turning operation will be preferred more?

Which of the following can produce both external as well as internal threads?

Distance from one point of thread to the next corresponding point is known as

Let screw of 10mm pitch is needed to be cut on lathe machine. Lead screw of lathe has pitch of 6mm. Which of the following statement is correct?

Distance measured normal to the axis of part, between crest and root of thread is known as

Which of the following can be effectively used for holding eccentric job?

Which of the following is mostly used for holding bored part of the job?

The flow through a nozzle is regarded as

The pressure at which the steam leaves the nozzle is known as back pressure.

In a nozzle, whole frictional loss is assumed to occur between

The turbine, in which the general direction of the steam flow is parallel to the turbine axis, is called axial flow turbines

The critical pressure gives the velocity of steam at the throat equal to the velocity of sound.

Thermal equilibrium means that the flow of steam is

The discharge is __________ at critical pressure.

The steam leaves the nozzle at a

The action of steam in a steam turbine is

The blade velocity coefficient is ratio of relative velocity of steam at outlet tip of the blade to the relative velocity of steam at inlet tip of the blade.