NEW
Font size
WorksheetsWood Members Cutting, Notching, and Boring Quiz
Total questions: 15
Worksheet time: 8mins
What is the maximum depth of notches on the ends of joists?
One-third the joist depth
One-fourth the joist depth
One-fifth the joist depth
One-sixth the joist depth
In exterior walls and bearing partitions, what is the maximum depth to which a wood stud is permitted to be cut or notched?
20 percent of its width
25 percent of its width
35 percent of its width
30 percent of its width
What is the maximum diameter of bored holes in wood studs in nonbearing partitions?
50 percent of the stud depth
70 percent of the stud depth
80 percent of the stud depth
60 percent of the stud depth
Who prescribes the cutting, notching, and boring of holes in structural steel framing members?
The building owner
The construction manager
The registered design professional
The building inspector
What is the maximum width of holes in webs of nonstructural cold-formed steel wall studs?
2 inches
2.5 inches
1.5 inches
1 inch
What is the maximum length of holes in webs of nonstructural cold-formed steel wall studs?
3 inches
3.5 inches
4 inches
4.5 inches
What is the minimum spacing between holes in webs of nonstructural cold-formed steel wall studs?
20 inches center to center
22 inches center to center
24 inches center to center
26 inches center to center
What is the maximum distance of holes from the bearing end in nonstructural cold-formed steel wall studs?
11 inches
10 inches
9 inches
8 inches
What is the maximum depth to which a wood stud is permitted to be cut or notched in nonbearing partitions supporting no loads other than the weight of the partition?
30 percent of its width
35 percent of its width
40 percent of its width
45 percent of its width
What is the maximum diameter of bored holes in wood studs in any wall where each stud is doubled?
80 percent of the stud depth
50 percent of the stud depth
60 percent of the stud depth
70 percent of the stud depth
What is the minimum distance of the edge of the bored hole from the edge of the stud?
3/4 inch
7/8 inch
5/8 inch
1/2 inch
What is the maximum depth of notches in the top or bottom of joists?
One-eighth the depth
One-seventh the depth
One-sixth the depth
One-fifth the depth
What is the maximum distance of holes from the bearing end in nonstructural cold-formed steel wall studs?
8 inches
11 inches
9 inches
10 inches
What is the maximum distance of holes from the bearing end in nonstructural cold-formed steel wall studs?
10 inches
8 inches
9 inches
11 inches
What is the maximum distance of holes from the bearing end in nonstructural cold-formed steel wall studs?
11 inches
10 inches
9 inches
8 inches
