NEW
Font size
WorksheetsSt. Helens college Chop saw competency Assessment
Total questions: 20
Worksheet time: 10mins
What is the primary material miter saws are intended to cut?
Stone
Plastic
Wood or wood-like products
Metal
Why is it not recommended to use gloves while operating a mitre saw?
They can get caught in the blade
They can reduce grip
They are too expensive
They can melt due to heat
What class of dust extractor is recommended for use with miter saws?
L-class
S-class
A-class
M-class or H-class
What should you do before returning the saw to the rest position after a cut?
Remove the dust bag
Wait for the blade to stop
Unplug the saw
Clean the saw
What is the correct action if a workpiece is too short to safely cut with a mitre saw?
Use a hand saw instead
Proceed with extra caution
Use an alternative tool
Clamp the workpiece harder
What should be done to the workpiece before making a cut with a mitre saw?
Paint it
Clamp or secure it in place
Measure it twice
Apply lubricant
What is a possible incident that might occur, to make you decide not to use another person as a substitute for a table extension or material support?
It can lead to inaccurate cuts
It's against safety regulations
It can cause the blade to bind
It's unprofessional
What safety equipment is recommended when operating a mitre saw?
Steel-toed boots
Gloves and knee pads
Safety Boots, glasses, ear protection, dust extraction, and a face mask
A hard hat
Why is it important to make sure the saw is secured on a level, firm work surface before use?
To make it easier to clean
To avoid damaging the saw
To prevent the saw from moving
To reduce the risk of the miter saw becoming unstable and tipping
What important procedures must take place before anyone can use a chop saw?
Training undertaken and competency recorded and filed.
Your Tutor must be notified
Your Tutor must be present
The correct PPE should be worn at all times
all of these answers
It is good practice secure the timber with your fingers tucked underneath rather than extended out?
True
False
When working in a workshop your actions ( wrestling, horseplay, pushing, and general disruptive behaviour) could cause a series accident on a chop-saw?
True
False
If you are standing near or helping someone who is using a chop saw you also by law should be wearing PPE and acting safely and professionally.
True
False
What is the recommended distance to keep your hands from the blade while operating a mitre saw?
25mm
70mm
150mm
250mm
Which of the following is a common cause of kickback when using a mitre saw?
Using a dull blade
Cutting too slowly
Applying too much pressure
Not using a dust extractor
What should you check before starting a cut with a mitre saw?
The blade is sharp and properly installed
The power cord is unplugged
The saw is in storage mode
The work area is cluttered
What should you do if the mitre saw blade becomes dull during operation?
Continue using it until the job is done
Replace or sharpen the blade immediately
Apply more pressure to cut through
Use a different tool
Which of the following is a safe practice when changing the blade on a mitre saw?
Leave the saw plugged in
Wear gloves to protect your hands
Ensure the saw is unplugged and the blade has stopped
Use a wrench to hold the blade in place
What is the purpose of using a dust extractor with a mitre saw?
To keep the work area clean
To improve visibility of the cutting line
To reduce airborne dust and improve air quality
To cool down the saw blade
Which of the following is a sign that the mitre saw blade needs replacement?
The blade is shiny and smooth
The saw makes a high-pitched noise
The cuts are rough and uneven
The saw is cutting faster than usual
