The heating, ventilation, and air conditioning systems inspection includes verifying the proper operation of the _____.

When inspecting a vehicle lifted on a hoist, check all of the following, except:

When performing an oil change, carefully inspect _____.

Most modern ignition systems use a coil-on-plug (COP) design that eliminates the _____.

_____ oils provide adequate lubrication at both low and high operating temperatures.

If the tire size is P195/60R14, the section width is _____.

A disc brake inspection includes checking all of the following parts, except:

A drum brake inspection includes checking all of the following parts, except:

All of the following are examples of diagnostic trouble codes, except:

When measuring resistance on a digital multimeter, what does a reading of “OL” on the meter mean?

When measuring brake disc runout, the dial indicator tip should touch the _____ as the disc is rotated.

Technician A says to verify the operation of the power mirrors when inspecting the vehicle interior. Technician B says that if a vehicle is equipped with a convertible top, the top should be inspected and tested during a vehicle inspection. Who is correct?

Technician A says the heating, ventilation, and air conditioning systems check should be performed when the vehicle’s engine is cold. Technician B says the engine idle quality should be checked during the test-drive. Who is correct?

Technician A says the oil seal on the new filter should be installed dry. Technician B says the oil seal from the old filter should be reused on the new filter. Who is correct?

Technician A says to change the serpentine belt while the engine is running. Technician B says to remove the water pump in order to remove the serpentine belt. Who is correct?

Technician A says the tire pressure should be set according to the tire information sticker in the door jamb. Technician B says an air chuck connected to a compressed air system should be used to inflate a tire that has low air pressure. Who is correct?

Technician A says single-viscosity oils are not typically used in modern automobile engines. Technician B says if the oil light does not turn off or the oil pressure gauge does not show oil pressure after adding new oil during the oil change and starting the engine, turn off the engine immediately and recheck the oil level. Who is correct?

Technician A says brake pad thickness variation between the inner and outer pad is a normal condition. Technician B says in a drum brake assembly, one of the new replacement brake shoes will have three to four times more friction material than the other shoe. Who is correct?

Technician A says a DTC with the letter U as the first code letter indicates a network code. Technician B says a DTC with the letter E as the first code letter indicates an engine code. Who is correct?

Technician A says low tire pressure can affect vehicle handling. Technician B says inflating a tire to a pressure 5–10 psi lower than the manufacturer’s specifications will increase vehicle fuel economy. Who is correct?

Technician A says a worn EPDM belt will wear away material similar to the way tire tread wears down. Technician B says a worn neoprene belt will show signs of cracking when it is worn. Who is correct?

Technician A says a serpentine belt that displays serve cracking and wear should be marked “Service Required.” Technician B says a broken brake light switch, which causes the brake lights to not work, should be marked as “Service Suggested.” Who is correct?

Technician A says the drain plug washer should be replaced every time the drain plug is removed. Technician B says the correct torque value should be used to tighten the drain plug. Who is correct?

Technician A says the standard drain plug torque value for all gasoline engines is 65 foot-pounds. Technician B says the oil filter should only be changed once it becomes clogged and no longer allows oil flow. Who is correct?