WorksheetsAE03 P2
Total questions: 14
Worksheet time: 7mins
Which way do electrons flow in an electrical circuit?
South to north
North to south
Positive to Negative
Negative to positive
Identify the component shown.
Surge protection diode
Regulator
Rectifier
Stator
Identify the component shown.
Rotor
Armature
Field coil
Commutator
When fitting new starter bushes, what must be done prior to fitment?
They must be reamed to size
They must be ground to size
They must be impregnated with oil
They must be greased
Identify the component shown below.
Rectifier
Resistor
Field winding
Solenoid
A starter motor is presented to you for testing which is clicking but not turning. You suspect the solenoid is the fault but what would be the most logical test to start with?
Resistance test between the solenoid trigger connector and the output connector
An insulation test on the solenoid cap, looking for a voltage leak
A volt drop test across the input/output connectors
Resistance test between the solenoid trigger connector and earth
Identify the component shown.
Regulator
Stator
Rectifier
Rotor
When you carry out a stator test you should carry out two tests. These would be:
voltage output test and an insulation test
resistance test and a current draw test
current draw test and voltage output test
resistance test and an insulation test
In a DC generator where is the rectification carried out?
The field windings
The dynamo regulator
The rectifier
The commutator
A typical conductor would be?
Wood
Copper
Glass
Rubber
Identify the component shown below
Armature
Solenoid
Field coil
Drive gear
What would be visibly different about an insulated return starter motor compared to an earth return starter motor?
The solenoid would have a third large output post
There would be an additional post on the starter motor
There would be an additional insulated earth post on the starter motor
There would be an additional earth wire from the starter mounting bolts
Identify the component shown.
Field coils
Armature
Stator
Commutator
Which one of the following test meters must be connected in series?
Voltmeter
Ammeter
Dwell meter
Ohmmeter
