WorksheetsVehicle Maintenance and Steering Systems
Total questions: 31
Worksheet time: 38mins
which would be the most likely result of adding the wrong steering fluid to a vehicle with rack and pinion steering
bearing failure
electrical failure
gear failure
seal failure
where would one most likely find the air suspension system disable switch on a vehicle
in the trunk
in the glove box
in the center console
under the seat
if a vehicle is making a whining noise when the steering wheel is turned, what is the most likely cause
the alternate belt has come off
the alternator is under charging
the power steering belt has come off
the power steering fluid is low
installing taller tires on a vehicle would cause the vehicles speedometer to
read faster
read slower
stop working
start fluctuating
a tire is found to have a nail hole in the sidewall.Which should be done?
repair the tire with a patch from the inside
repair the tire with a string type plug
replace the tire sidewall with a vulcanizing kit
replace the tire
which is most likely tool for a technician to use to find a noise traveling through the suspension system
vibration anlyzer
chassis ears
test light
scantool
where on a tire should a technician test its pressure
sidewall
valve stem
center cap
tread
which part in the front suspension is located between the steering gear and center link
control arm
idler arm
pitman arm
track arm
any of the following would likely indicate the correct power fluid to be used in a vehicle except
parts and labor guide
a technical service bulletin
owners manual
service manual
what type of suspension incorporates the shock absorber and coil spring in one assembly
strait axle
twin 1 beam
MacPherson strut
SLA
which noise is heard during a scheduled maintenance test-drive would least likely be scheduled for repair
belt squeal
brake squeal
tire noise
wind noise
before working on a hybrid vehicles electrical power steering system, which PPE should a technician wear
insulated gloves rated at 200 volts
insulated gloves rated at 400 volts
insulated gloves rated at 800 volts
insulated gloves rated at 1000 volts
if a rear wheel spindle is bent, which is the best way to repair the spindle
heat and bend it
replace it
realign it
add shims to it
the spindle assembly at the rear of the vehicle shows signs of severe wear. which could be the cause?
dry wheel bearings
incorrect caster
incorrecting toe setting
worn rear tires
where would one find the tire info place card on a vehicle listing the recommended tire size and pressure for that vehicle
under the hood
on the door jam
in the trunk
in the center console
which would be the most likely result of under-torquing lug nuts
the wheel may fall off
the tire may run hot
the tire may run flat
the eas may drag
it is important to torque wheel lug nuts or bolts to OEM specs, and in the correct sequence, in order to help prevent:
brake pistons from binding
the breaks from squealing
the brake drums from cracking
the break rotors from warping
what might a technician need to check the operation of break lights on the rear of a vehicle
a computer
a helper
a sensor
a ratchet
what part of the drum brake assembly Is filled with brake fluid
anchor pin
master cylinder
shoe
wheel cylinder
all of the following are types of brake fluid except
DOT 2
DOT 3
DOT 4
DOT 5
when diagnosing a vehicle with vibrating brake pads, which parts are most likely missing
anti-rattle clips
anti-fatigue clips
anti-wear clips
anti-float clips
when refilling a brake master cylinder, always use:
DOT 3 brake fluid
DOT 5 brake fluid
OEM-specific brake fluid
synthetic brake fluid
where would one most likely find the master cylinder on a vehicle
in front of the pedal under the hood
the brake pedal in the passenger compartment
under the vehicle beneath the drivers seat
under the hood near the radiator
what is the most likely cause of brake lights staying on
blown fused
stuck brake light switch
wrong brake fluid
wring brake light bulbs
which type of brake fluid is synthetic
DOT 2
DOT 3
DOT 4
DOT 5
if lug nuts are torqued improperly when wheels are installed, which brake parts could be warped
calipers
pads
drums
rotors
where is the red brake warning light located on a vehicle
in the hood
in the dash
in the master cylinder
in the glove box
over torquing lug nuts can cause:
damage to wheel studs
improved fuel economy
poor fuel economy
the wheel to fall off
which part in the drum brake system expands outward against the drum to stop a vehicle when brakes are applied
pads
shoes
bushings
springs
a vehicles red brake warning light stays on whenever the ignition is on and the engine is running. any of the following could be the cause except
the ABS has a faulty wheel sensor
the brake fluid is low in the reservoir
the parking brake is engaged
the parking brake switch is out of adjustment
DOT 3 brake fluid can safely be mixed with what other brake fluid type
DOT 1
DOT 2
DOT 4
DOT 5
