Wayground logo

Free Printable Worksheets

Font size

S
M
L
XL
Worksheets

Phcc Ch 13

Total questions: 10

Worksheet time: 5mins

Name
Class
Date
1.

This type of water heater uses a heat source to gradually heat water in a tank to a desired set point.

a)

storage or tank type

b)

high energy

c)

tankless

d)

gradual

2.

Tank-type water heaters:

a)

are the least commonly used.

b)

are lower in energy loss.

c)

require a greater equipment footprint.

d)

have more complex controls.

3.

Tankless water heaters:

a)

have higher initial costs.

b)

have a lower BTU per hour rating.

c)

have lower energy input rates.

d)

have less complex controls.

4.

What are possible heat sources for a storage-type water heater?

a)

A separate boiler.

b)

Solar panels.

c)

Its own input source and controls.

d)

All are correct.

5.

What are the two key factors when deciding on storage tank size?

a)

heating demands

b)

recovery rate

c)

geography

d)

A and B

6.

Tankless water heaters do not store any hot water in reserve. Therefore, they:

a)

require a gas system with larger diameter pipes or higher pressures.

b)

must convert fuel at a higher rate than storage tank models.

c)

A, B, and D

d)

must use heavier gauge wire or higher voltage.

7.

A point-of-use electric water heater:

a)

allows small amounts of water to be delivered to the fixture instantly.

b)

means the user does not have to run the water until the hot water reaches the fixture.

c)

A, B, and D.

d)

allows large amounts of water to be conserved.

8.

__________ use either a fuel-fired or electric element to heat the water.

a)

Direct-fired tankless units

b)

In-direct tankless units

c)

Hot water heaters

d)

Solar water heaters

9.

In an indirect-fired water heater, what is passed through a coil or containment tank that is in turn directly connected to the potable water source?

a)

oil, gas, tube, pipe

b)

steam, hot water, coil, containment tank

c)

steam, hot water, tube, pipe

d)

oil, gas, coil, containment tank

10.

Solar energy collectors are usually divided into three categories: __________, __________, and __________.

a)

radiators, conductors, convectors

b)

low temperature, medium temperature, concentrators

c)

low temperature, medium temperature, high temperature

d)

drain back, high pressure, vacuum tube