WorksheetsSETTING OUT
Total questions: 20
Worksheet time: 10mins
What is the first step in building setting out procedure?
Install profile boards
Establish the frontage line and mark it on site
Dig trenches
Set column layout
What does the frontage line represent?
Road curb or center line reference
The back wall position
The height of building
Roof slope indicator
What is done after establishing the base line?
Paint the floor
Install steel bars
Mark and check the main building lines
Erect scaffolding
Which tool is used to mark building corners on the ground?
Paint
Stout Peg
Rope
Concrete Post
Which equipment is used to measure long distances on site?
Ruler
Steel measuring tape
Folding Meter
Measuring Tape
What is the purpose of diagonal check during setting out?
To set column height
To align the roof slope
To ensure corners are at right angles
To confirm wall thickness
After all angles and lengths are confirmed, what is the final step?
Lay bricks
Set up profile boards at each building corner
Install electrical wiring
Pour foundation
Which line is closest to the road and allowed by local authorities?
Base line
Back line
End wall line
Wall center line
Which tool is commonly used to check right angles during setting out?
Compass
Spirit Level
Crowbar
Builders Square
What is used to mark exact reference points on the ground?
Wooden Peg
Rope
Hammer
Rebar
What tool is used to stretch and align layout lines between batter boards?
Nail Gun
Bolt Cutter
Plumb Bob
String Line
What tool is used to ensure a level line across profile boards?
Spirit Level
String Line
Measuring Tape
Plumb Bob
Which equipment is used to check vertical alignment during setting out?
Plumb Bob
Water Level
Set Square
Tape Measure
What is typically used to support the batter board structure?
Rope
Hammer
Brace
Nail
What is the function of a batter board in the profile board setup?
To support the base slab
To hold strings that mark wall lines
To anchor pegs
To measure trench depth
Which part of the profile board holds the batter board above ground?
Stake
Brace
String
Peg
What is the purpose of the brace in a profile board?
To create angles
To mark the center line
To measure distance
To stabilize the batter board
The string line tied across batter boards is used to mark:
Door opening positions
The center and outer wall lines
The building roof level
Plumbing locations
Which tool is used to ensure all profile boards are level?
Tape measure
Hammer
Spirit level
Laser Cutter
What must be done before setting up the profile boards?
Build the walls
Complete diagonal check
Set up site hoarding
Dig the foundation
