NEW
Font size
WorksheetsEHS&S Year End Challenge - Round 3 (English)
Total questions: 20
Worksheet time: 20mins
What is one way Mattel reduces water consumption in its facilities?
Installing larger water tanks
Replacing old fixtures with low-flow fixtures
Increasing water pressure to reduce flow time
Using bottled water instead of tap water
Low-flow faucets can reduce water usage by approximately how much compared to older models?
10% or more
20% or more
30% or more
50% or more
What reuse opportunity does Mattel consider from the air conditioning (AC) system?
Using AC condensate water for irrigation or cooling towers
Collecting AC condensate water for drinking water
Redirecting AC condensate water into storm drains
No reuse opportunity identified from AC condensate water
Which category uses the most energy in Mattel’s facilities?
Lighting
Cooling water systems
Production equipment
Forklifts and fleet vehicles
What types of vehicles are prioritized for Mattel’s new fleet acquisitions?
Gasoline-powered vehicles
Diesel trucks
Hybrid vehicles
Electric vehicles
Approximately what percentage of total energy use in Mattel facilities is attributed to lighting?
5 %
6 %
7 %
8 %
During a shift, you begin to feel numbness in your hand from repetitive lifting. What is the correct response?
Continue working and see if the discomfort improves
Adjust your posture and ignore the numbness
Report the symptoms to your supervisor immediately
Change to a lighter task without notifying anyone
True or False. Reporting early signs of soreness, numbness, or discomfort is part of Mattel’s ergonomics guidelines.
True
False
Repetitive motion injuries are most often caused by ________ exposure to a combination of risk factors such as force, posture, and frequency.
Short-term
Prolonged
Immediate
Occasional
A forklift has been parked with the keys left inside, although the engine is switched off. What is incorrect in this situation?
This is acceptable since the engine is off
The keys must be removed whenever the forklift is parked
This only matters during night shifts
It is fine if no pedestrians are nearby
During a pre-shift inspection, you notice that a forklift is leaking fluid. What should you do?
Continue using it until a replacement is available
Stop operation, apply lockout/tagout, and report the issue
Place absorbent pads under the leak and continue working
Use it only for short-distance movement
While operating a forklift, you notice a coworker walking approximately 1 meter (3.3 feet) away from your vehicle. According to HALO Zone principles, this means they are in the:
Safe Zone
Red Zone
HALO Zone
Yellow Zone
When a pedestrian enters the HALO Zone (within 0.9 meters / 3 feet of a powered industrial vehicle), what must the operator do immediately?
Slow down and make eye contact
Stop the vehicle, lower the forks, set the parking brake, and remove hands from controls
Sound the horn and continue carefully
Ask the pedestrian to step back before continuing
You find a damaged rack crossbeam on a high-level shelf that appears to be bent from a forklift impact. What immediate action should you take?
Place a "Caution" note on the damaged beam
Continue using other parts of the rack while avoiding the damaged area
Take the damaged racking out of service immediately and report it to your supervisor
Try to hammer the beam back into shape with a tool
True or False. If dedicated metal decking is unavailable, sturdy wooden planks can be used temporarily to replace a damaged deck on a rack.
True
False
Which information must be clearly posted on all racks and overhead storage platforms to ensure safe use?
The number of rack levels
The number of shelves installed
The type of rack material
The maximum load ratings
Which of the following is strictly prohibited from being discharged into stormwater systems?
Rainwater
Industrial wastewater
Sanitary sewage
Treated cooling water
Hazardous waste storage areas must be inspected at least how often to ensure compliance?
Daily
Weekly
Monthly
Quarterly
Off-site storage of hazardous waste is only permitted with the approval of:
The Site leader
The Site EHS lead
Global EHS
No approval is required
All waste generated by the facility needs to be:
Estimated by weight and recorded once annually
Weighed accurately and tracked through the UL 360 system
Stored on-site until disposal contractors are available
Recorded only if the waste is classified as hazardous
