WorksheetsDay 33_22Oct_ITI_ ED-Lines
Total questions: 15
Worksheet time: 10mins
Mention the IS Code used for drawing
(a)
Which line is used for drawing object boundaries
(a)
The line shown is used for____________
a) Long-break line
b) Cutting planes
c) Centroidal lines
d) Out lines of adjacent parts
In engineering drawing, which type of line indicates that there is a change of plane?
a) Continuous thin wavy
b) Long chain thin
c) Continuous thick
d) Medium thick short dashes
From the figure, what is the name of the line X?
a) Outline
b) Section line
c) Hidden line
d) Hatching
A chain thin thick at edges indicate_____
Cutting plane
Change in direction of cutting
Both a & b
None of these
A miter line represents the ____ of a section and is drawn at an angle ___ to project points or lines from one view to next
(a)
The axis of the cylinder or sphere is denoted by which of the following line?
a) Section line
b) Centre line
c) Hidden line
d) Leader line
Which of the following lines are used to show that the object is cut and then viewed?
a) Hidden lines
b) Leader lines
c) Centre lines
d) Hatching Lines
What is the length of the short dashes of the centre lines?
5 mm
2 mm
1 mm
3 mm
What is the difference between the section line and the centre line?
a) The length of the long dashes
b) The length of short dashes
c) The width of the gap
d) The two ends of the lines
The line given is used for_________________
a) Hidden outlines
b) Cutting planes
c) Hidden edges
d) Dimension lines
Match the correct pairs
(a)
Match the correct pairs
(a)
Short-break lines are drawn freehand while long-break lines are ruled lines.
