All of the following problems or conditions may be caused by improper wheel balance, EXCEPT:

Technician A says when checking a tire's air pressure, always refer to the tire sidewall information, and inflate the tire to that pressure. Technician B says when checking air pressures, compare them to the specifications on the tire placard usually located on the driver's door, door pillar, or glove compartment lid. Who is correct?

The wear patterns on a tire correlate with damage to particular vehicle components.

The cold inflation pressure of a tire is determined based on the:

Tires and wheels must be balanced statically and dynamically.

________ imbalance occurs when the wheel or tire is not concentric or when the tire's sidewall has uneven stiffness.

Which of the following is a clear indicator that the tire is at the end of its legal life?

Over inflation of a tire causes excessive wear on the outer edges of the tread.

_______ is most commonly a result of the tires set with excessive toe-in or toe-out.

A ________ is used to apply pressure to the patch when positioning it.

A dragging front brake assembly can cause heavy pulling of a vehicle to either the left or the right.

Technician A says that a tire will increase or decrease approximately 1 psi for each 10°F change of temperature. Technician B says that if the vehicle has been driven to warm the tires, you must adjust the air pressure down to the manufacturer's recommended pressure. Who is correct?

Technician A says that dismounting and mounting a tire is the same process on all modern wheels. Technician B says that the tire pressure monitoring system has changed mounting and dismounting procedures on some vehicles equipped with TPMS. Who is correct?

Tech A says that it is a good practice to cover the buffed area and newly applied plug patch with a rubber patch sealant. Tech B says that it is good practice to use the mechanical buffer tool to smooth the plug patch after it has been applied. Who is correct?

Wheel and tire assembly runout is a condition defined by all of the following, EXCEPT:

Tech A says that an outside micrometer is used to measure axle flange runout. Tech B says that lateral runout of the tire, wheel, or axle flange causes the wheels to jiggle side to side. Who is correct? Select one:

Two technicians are discussing tire puncture repair using a tire patch. Technician A says that you should use a tire buffer to smooth the area around the hole. Technician B says that a liquid buffing solution should be used to scrub the area just buffed. Who is correct? Select one:

If the TPMS warning light indicates a system fault, connect an appropriate scan tool to the system and read any _________. Select one:

Tech A says that using a tire plug to repair a hole in a tire is the best and fastest way to fix a tire. Tech B says that using a tire plug patch is the only approved method of repairing a tire in many states. Who is correct? Select one: