WorksheetsThe final boss
Total questions: 10
Worksheet time: 10mins
A vehicle is having an alignment performed and these are the current measurements.
L/F camber 1 degree 25 minutes
R/F camber 0 degree 5 minutes
L/F toe 0 degrees 25 minutes
R/F toe 0 degrees - 25 minutes
Factory Camber spec is 10 minutes +/-
Factory Toe spec is 5 minutes +/-
What will be the driving characteristics of this vehicle?
Pull to the right and steering off to the right
Pull to the left and steering off to the right
Pull to the right and steering off to the left
Pull to the left and steering wheel off to the left
What is the maximum runout allowance on a rotor?
.7mm
.030mm
.070mm
.007mm
Graphing alignments are performed to reduce
ride height
adjustments causing wear
thrust angle
potential out of spec setback
Out of spec Caster can cause this type of tire wear
Smooth wear on the inside
Choppy or cupping wear
No evident wear
Smooth wear on the outside
Client states their vehicle is skipping/jerking while turning. Which alignment angle could be at fault?
Front Camber
Max steering angle
Rear setback
Rear Camber
Negative thrust angle could cause the vehicle to crab walk. What would be the characteristics on the steering wheel?
Off to the left
Off to the right
No effect
shimmy
When DSCI detects a failure, it goes into this mode
Fall forward mode
Fail safe mode
Fall back mode
Fail back mode
A client complains of a soft brake pedal while stopping on a vehicle equipped with DSC. What could be the issue?
Pads below min spec
Out of spec rotor runout
Brake booster
Master cylinder
A vehicle equipped with DSCi throws a DSC and Brake malfunction light on. A technician performs a fault check and notices there is a Brake pedal travel sensor short to battery positive fault. What is the job of this sensor?
Provides a signal to the shift interlock solenoid
Provides power to the brake lights
Records brake pedal pressure
Records brake pedal travel speed.
Which angle when adjusted affects ride height?
Caster
Camber
Toe
Setback
