Font size
WorksheetsCCNA1 - Module 3 - Protocols and Models - Quiz
Total questions: 65
Worksheet time: 44mins
What is the process of converting information into the proper form for transmission?
Formatting
Encoding
Encapsulation
What is the process of converting information into the proper form for transmission?
Formatting
Encoding
Encapsulation
Which step of the communication process is concerned with properly identifying the address of the sender and receiver?
Formatting
Encoding
Encapsulation
Which three are components of message timing?
Flow control
Sequence numbers
Access method
Retransmit time
Response timeout
Which delivery method is used to transmit information to one or more end devices, but not all devices on the network?
Unicast
Multicast
Broadcast
What type of communication will send a message to all devices on a local area network?
(Ενιαία Γραπτή Αξιολόγηση Α' Τετραμήνου - 2021-22 - Σειρά Β')
allcast
multicast
unicast
broadcast
In computer communication, what is the purpose of message encoding?
to interpret information
to negotiate correct timing for successful communication
to break large messages into smaller frames
to convert information to the appropriate form for transmission
Which message delivery option is used when all devices need to receive the same message simultaneously?
(Ενιαία Γραπτή Αξιολόγηση Α' Τετραμήνου - 2022-23 -Σειρά Α')
unicast
duplex
multicast
broadcast
Which type of communication will send a message to a group of host destinations simultaneously?
unicast
multicast
anycast
broadcast
Which message delivery option is used when a group (not all) of devices need to receive the same message IPv4 simultaneously?
(Ενιαίες Τελικές Προαγωγικές Γραπτές Εξετάσεις 2024-25 - Σειρά Β')
broadcast
multicast
anycast
unicast
What process is used to receive transmitted data and convert it into a readable message?
(Ενιαίες Τελικές Προαγωγικές Γραπτές Εξετάσεις 2024-25 - Σειρά Β')
access control
flow control
decoding
encapsulation
BGP and OSPF are examples of which type of protocol?
network communication
network security
routing
service discovery
Which two protocols are service discovery protocols?
DNS
TCP
SSH
DHCP
What is the purpose of the sequencing function in network communication?
to uniquely label transmitted segments of data for proper reassembly by the receiver
to determine if data is corrupted during transmission
to ensure data flows at an efficient rate between sender and receiver
to guarantee delivery of data
This protocol is responsible for guaranteeing the reliable delivery of information.
TCP
IP
HTTP
Ethernet
UDP and TCP belong to which layer of the TCP/IP protocol?
application
transport
internet
network access
Which two protocols belong in the TCP/IP model application layer?
EIGRP
DNS
OSPF
ICMP
DHCP
What layer is responsible for routing messages through an internetwork in the TCP/IP model?
(Ενιαία Γραπτή Αξιολόγηση Α' Τετραμήνου 2022-23 - Σειρά Β')
network
internet
transport
data link
Which protocol operates at the network access layer of the TCP/IP model?
HTTP
IP
DNS
Ethernet
Which of the following are protocols that provide feedback from the destination host to the source host regarding errors in packet delivery?
ICMPv6
IPv6
ICMPv4
IPv4
TCP
A device receives a data link frame with data and processes and removes the Ethernet information. What information would be the next to be processed by the receiving device?
HTTP at the application layer
HTML at the application layer
IP at the internet layer
UDP at the internet layer
TCP at the transport layer
Which services are provided by the internet layer of the TCP/IP protocol suite?
File Transfer
Internet Protocol
Address Resolution
Messaging
Routing Protocols
What is the purpose of protocols in data communications?
specifying the device operating systems that will support the communication
providing the rules required for a specific type of communication to occur
specifying the bandwidth of the channel or medium for each type of communication
dictating the content of the message sent during communication
A web client is sending a request for a webpage to a web server. From the perspective of the client, what is the correct order of the protocol stack that is used to prepare the request for transmission?
HTTP, TCP, IP, Ethernet
Ethernet, IP, TCP, HTTP
HTTP, IP, TCP, Ethernet
Ethernet, TCP, IP, HTTP
Standards organizations are usually vendor-neutral.
True
False
This standards organization is concerned with the Request for Comments (RFC) documents that specify new protocols and update existing ones.
Internet Society (ISOC)
Internet Engineering Task Force (IETF)
Internet Architecture Board (IAB)
Internet Research Task Force (IRTF)
This standards organization is responsible for IP address allocation and domain name management.
Internet Society (ISOC)
Internet Engineering Task Force (IETF)
Internet Architecture Board (IAB)
Internet Assigned Numbers Authority (IANA)
Which three acronyms/initialisms represent standards organizations?
TCP/IP
EIA
MAC
IETF
IANA
What types of standards are developed by the Electronics Industries Alliance (EIA)?
electric wiring and connectors
radio equipment and cell towers
video compression and broadband communications
Voice over IP (VoIP) and satellite communications
What are the benefits of using a layered network model?
Choose three.
It assists in protocol design.
Promotes competition because products from different vendors can work together
It prevents technology in one layer from affecting other layers.
It speeds up packet delivery.
It ensures a device at one layer can function at the next higher layer.
What is the purpose of the sequencing function in network communication?
to uniquely label transmitted segments of data for proper reassembly by the receiver
to determine if data is corrupted during transmission
to ensure data flows at an efficient rate between sender and receiver
to guarantee delivery of data
Which protocol operates at the network access layer of the TCP/IP model?
HTTP
IP
DNS
Ethernet
A device receives a data link frame with data and processes and removes the Ethernet information. What information would be the next to be processed by the receiving device?
HTTP at the application layer
HTML at the application layer
IP at the internet layer
UDP at the internet layer
TCP at the transport layer
What is the process of dividing a large data stream into smaller pieces prior to transmission?
sequencing
duplexing
multiplexing
segmentation
What is the PDU associated with the transport layer?
segment
packet
bits
frame
What process involves placing one Protocol Data Unit (PDU) inside of another PDU?
(Ενιαία Γραπτή Αξιολόγηση Α' Τετραμήνου 2021-22 - Σειρά Α')
encapsulation
encoding
segmentation
flow control
Which name is assigned to the transport layer PDU?
(Ενιαία Γραπτή Αξιολόγηση Α' Τετραμήνου - 2022-23 - Σειρά Β')
packet
segment
frame
data
Which protocol stack layer encapsulates data into frames?
data link
transport
network
application
What is the name of the process of adding protocol information to data as it moves down the protocol stack?
de-encapsulation
sequencing
segmentation
encapsulation
What is the purpose of protocols in data communications?
specifying the device operating systems that will support the communication
providing the rules required for a specific type of communication to occur
specifying the bandwidth of the channel or medium for each type of communication
dictating the content of the message sent during communication
What is the general term that is used to describe a piece of data at any layer of a networking model?
(Ενιαία Γραπτή Αξιολόγηση Α' Τετραμήνου - 2022-23 - Σειρά Α')
segment
frame
protocol data unit
packet
Which layer of the OSI model defines services to segment and reassemble data for individual communications between end devices?
application
session
transport
network
presentation
Drag and drop each TCP/IP protocol suite layer and its relevant PDU .
Identify the layers of the OSI model shown in the diagram and their relevant PDUs. (Drag and Drop)
Drag and drop each TCP/IP protocol suite layer next to the function it supports.
Drag and drop each OSI layer next to the function it supports.
Complete the following table.
(2024-25 - Σειρά Β')
What is done to an IP packet before it is transmitted over the physical medium?
It is encapsulated into a TCP segment.
It is encapsulated in a Layer 2 frame.
It is segmented into smaller individual pieces.
It is tagged with information guaranteeing reliable delivery.
A web client is sending a request for a webpage to a web server. From the perspective of the client, what is the correct order of the protocol stack that is used to prepare the request for transmission?
HTTP, TCP, IP, Ethernet
Ethernet, IP, TCP, HTTP
HTTP, IP, TCP, Ethernet
Ethernet, TCP, IP, HTTP
Messages exchanged between devices in different IP networks must be forwarded to a default gateway.
True
False
The right-most part of an IP address is used to identify the network that a device belongs to.
True
False
What is used to determine the network portion of an IPv4 address?
subnet mask
MAC address
right-most part of the IP address
left-most part of the MAC address
When IPv4 addressing is configured manually on a web server, which property of the IPv4 configuration identifies the network and host portion for an IPv4 address?
(Ενιαίες Τελικές Προαγωγικές Γραπτές Εξετάσεις 2023-24 - Σειρά Α')
DNS server address
Subnet mask
Default Gateway
DHCP server address
Which of the following statements are true regarding network layer and data link layer addresses?
Network layer addresses are logical and data link layer addresses are expressed as 12 hexadecimal digits.
Data link layer addresses are logical and network layer addresses are physical.
Network layer addresses are either 32 or 128 bits in length.
Network layer addresses are expressed as 12 hexadecimal digits and data link layer addresses are decimal.
Data link layer addresses are physical and network layer addresses are logical.
What is the order of the two addresses in the data link frame?
source MAC, destination MAC
destination MAC, source IP
destination IP, source IP
destination MAC, source MAC
source IP, destination IP
Data Link addresses are physical so they never change in the data link frame from source to destination.
True
False
Which logical address is used for delivery of data to a remote network?
(Ενιαίες Τελικές Προαγωγικές Γραπτές Εξετάσεις 2024-25 - Σειρά Α')
source MAC address
source IP address
destination IP address
destination port number
destination MAC address
A web client is sending a request for a webpage to a web server. From the perspective of the client, what is the correct order of the protocol stack that is used to prepare the request for transmission?
(Ενιαίες Τελικές Προαγωγικές Γραπτές Εξετάσεις 2023-24 - Σειρά Β')
HTTP, TCP, IP, Ethernet
Ethernet, IP, TCP, HTTP
HTTP, IP, TCP, Ethernet
Ethernet, TCP, IP, HTTP
Which statement accurately describes a TCP/IP encapsulation process when a PC is sending data to the network?
(Ενιαίες Τελικές Προαγωγικές Γραπτές Εξετάσεις 2023-24 - Σειρά Α')
Data is sent from the Internet Layer to the Network Access Layer.
Packets are sent from the Network Access Layer to the Transport Layer.
Segments are sent from the Transport Layer to the Internet Layer.
Frames are sent from the Network Access Layer to the Internet Layer.
PC1 sends a message to PC2.
Specify the L2 and L3 addressing information when the message leaves PC1?
L2 Header: Destin. MAC (a) Source MAC (b)
L3 Header: Source IP (c) Destination IP (d)
PC2 sends a message to PC4
Specify the L2 and L3 addressing information when the message leaves PC2.
L2 Header: Destin. MAC (a) Source MAC (b)
L3 Header: Source IP (c) Destination IP (d)
PC2 sends a message to PC4
Specify the L2 and L3 addressing information when the message arrives at PC4.
L2 Header: Destination MAC (a) Source MAC (b)
L3 Header: Source IP (c) Destination IP (d)
Network Admin from PC3 remote controls S1
Specify the L2 and L3 addressing information when the message leaves PC3.
L2 Header: Destination MAC (a) Source MAC (b)
L3 Header: Source IP (c) Destination IP (d)
Network Admin from PC3 remote controls S1
Specify the L2 and L3 addressing information when the message arrives at S1.
L2 Header: Destination MAC (a) Source MAC (b)
L3 Header: Source IP (c) Destination IP (d)
PC4 sends a broadcast message to its network
Specify the L2 and L3 addressing information when the message leaves PC4.
L2 Header: Destination MAC (a) Source MAC (b)
L3 Header: Source IP (c) Destination IP (d)
