GLA01 - Module 2

Riveted and bolted door glass will typically have what between the glass and thefasteners?

• Rubber gaskets
• Plastic washers
• Metal channels
• Insulating tape

Technician A says that rubber glass runs should only be lubricated with powdered graphite. Technician B says that bent window channels can typically be straightened and reused. Who is right?

• A only
• B only
• Both A and B
• Neither A nor B

When adhesively bonding a glass into a channel with urethane adhesive:

• a rubber gasket should be placed between the glass and channel.
• the glass should be rolled up and down before the urethane dries.
• a two part urethane must always be used.
• the glass must be primed with the appropriate primer.

When cleaning up broken glass from a vehicle interior, all of these should be done EXCEPT:

• carefully remove the large pieces with a gloved hand.
• remove broken glass fragments from the runs with a special tool.
• vacuum up the small pieces with a back-and-forth motion.
• turn the blower motor on HIGH in the vent or A / C mode.

When adjusting a frameless door glass, adjustable travel stops are used to set the:

• in and out tilt of the glass.
• forward and rearward position of the glass in the door shell.
• height of the glass in the door shell.
• travel speed of the glass.