ATD GCOR Quiz 11

24.2.6 - 10.3 B

If the time limits on a Track and Time or Foul Time Permit is to be extended in the CAD system, the train dispatcher:

• Must include a repeat of the permit number.

• Must contact all persons holding joint permits and advise them of the change.

• Must not extend the time limits at all. The employee must clear the limits at the time shown on the original permit.

• Is not required to do anything

24.2.7 -

Before granting track and time with a switch yes or foul time to employees for protection in a control point, the dispatcher must:

• Advise affected trains that signal indications may change.

• The employee will be able to give a signal indication if necessary

• All trains in the area have received a joint foul time

• The work being performed will cause any Hours of Service violations

24.3 -

If it becomes necessary to issue track and time to an employee for the purpose of repairing the code line, trains must proceed through the outage limits how?

• Trains may not be authorized to proceed under these circumstances

• Trains must be authorized to proceed on track and time authority

• Trains may be verbally authorized to pass stop indication with no other instructions

18.1 -

A train must not be operated in PTC territory if the controlling locomotive is not equipped with an operable PTC system unless otherwise authorized by:

• Rule, Special Instruction or the Train Dispatcher

• The locomotive help desk

• The Yardmaster

• Any of the above

26.1 - 14.0

Use Box 12 only:

• When issuing a track warrant for bulletins

• When allowing a train to leave the main track switch open in Non- Block signal track warrant control territory

• To record computer-generated messages or specific instructions required to operate the train safely and efficiently

• To enter miscellaneous comments with regards to work events

26.1 - 14.0

When employees repeat a track warrant back to the dispatcher, the dispatcher must require the employee to:

• Read only the boxes that are X’ed and not read each word

• Read only the line numbers that are X’ed and not the words

• Include a summary of the total number of Boxes marked and naming each individual box marked

• Read the "Date" and "At Location"

26.1 - 14.0

Before the dispatcher verbally transmits a track warrant they must:

• Ensure the train is stopped

• Make sure the train has released the limits of the warrant they are currently occupying

• State intention to transmit track warrant and determine who will copy

• Ensure the train is operating at restricted speed

26.2 -

Care must be taken to ensure the correct track warrant is released. Train dispatcher’s repeat of release must include, at a minimum:

• Track Warrant number and occupation of employee releasing

• Track Warrant number, location of train, name of employee and reason for releasing

• Track Warrant number, release time, and name of employee releasing the warrant

• Track Warrant number only is needed for proper release

26.2.1 - TDCOB

Within non-signaled TWC territory, do not accept the release of a track warrant whose movement has cleared the main track through a hand-operated switch until:

• Confirmation has been received that no further movement authority is needed

• Their warrant contains a Box 12, instructing them to leave the switch lined for other than main track movement

• Confirmation has been received that the main track switches have been restored to the normal position and both conductor and engineer have signed the appropriate form

• Confirmation has been received that the main track switches have been left in the reverse position and both conductor and engineer have signed the appropriate form