Crit Line Blood Volume Monitor 1

How many minutes do you wait before clicking "Start Run" on the CLM III?

• No minutes, start when treatment started.

• 2 minutes

• 3 to 5 minutes

• 10 minutes

What is a "normal" O2 saturation with an AVF/AVG?

• 60%

• 80%

• above 90%

• Crit Line does not read O2 saturation

Why would an O2 saturation with a CVC read below 80%?

• The blood is darker

• CVC is in the arterial system

• CVC is in the venous system

• The blood flow rate is usually less

What is the minimum UF rate for plasma refill check?

• 70 ml/hr

• 250 ml/hr

• 100 ml/hr

• 300 ml/hr

How long is a plasma refill check?

• 2 minutes

• 5 minutes

• 10 minutes

• 15 minutes

What difference between plasma pre and post refill hematocrits suggests there may be more fluid?

• a decrease of 0.5 (34.6 to 34.0)

• an increase of 0.3 (34.6 to 34.9)

• a decrease of 0.3 (34.6 to 34.3)

• an increase of 0.5 (34.6 to 35.1)

What do you do with the CLM III sensor clip when changing a clotted extracorporeal circuit?

• Return to verification filter on CLM III

• Remove sensor clip and hang over the IV pole

• Shut off CLM III

Which hematocrit readings should be documented in ACES? Choose all that apply.

• initial HCT

• intra-procedure HCT

• ending HCT

• post plasma refill HCT

What is the recommended maximum blood volume change?

• +15%

• -15 %

• +10%

• -20%

After wiping the CLM III with 1:100 bleach, what is done next?

• Soak the sensor clip

• Disconnect all wires

• After allowing to dry, wipe bleach residue from screen and verification filter.