Set up and Operate Woodworking Machinery L2 Bench Joinery

A Thrust Wheel supports the blade on which machine ?

• Cross Cut Saw

• Radial Arm Saw

• Bandsaw

• Morticer

When using a surface planer, a dip in the trailing end of timber known as snipe is caused by ?

• Infeed table too low relative to the blades

• Outfeed table to high relative to the blades

• Outfeed table too low relative to the blades

• Side fence not set square

When planning short lengths of timber the operator should use ?

• Gloves

• A pushtick

• A pushblock

• A slow feed speed

When machining Mortise and Tenon joints which should be cut first ?

• The Tenon

• The Mortice

When changing the blades in a planning machine the best way to set the height of the blades so that they are all the same height is to ?

• Set them by eye

• Set them by measuring with a steel rule

• Use setting gauges designed for the machine

A planning machine should be fitted with ?

• A front Bridge guard

• A rear Bridge guard

• An adjustable Bridge guard

• Front and rear Bridge guards

A Ripsaw should be fitted with ?

• A positive hook blade

• A negative hook blade

• A TCT blade

• A HSS blade

TCT stands for ?

• Tungsten Carbide Tipped

• Tough Carbon Tooling

HSS stands for

• Hardened Steel Saw

• High Speed Steel

For saw blades over 600mm diameter the Riving Knife should be at least ?

• 225mm above the table

• 300mm above the table