Tools and consumables safety

Which of these checks would be made to a copper and hide hammer? there could be more than one.

• Date of expiry

• Loose Head

• Split handle

• Mushroomed head

One type of safety check to make to any plug in mains electricity equipment is?

• Check for year of manufacturer

• Check for the installers stamp

• Check the plug and cable for condition

• Check it runs at full speed

Which of the following would not be a check for a garage product supplied in a can?

• check for leaks

• check for sharp edges

• check for cracked glass

• Check for product warning labels

Which of these substances give of dangerous vapours?

• WD 40

• engine oil

• copper grease

• Tyre patch adhesives

What is this equipment called?

• Sight glass

• Reflectometer

• Hydrometer

• Refractometer

Safe use of product information can be found on:

• Side of container and manufacturers safety data sheet

• Workshop manual and Autodata

• Risk assessments and COSHH book

• Workshop wall chart

What does WD stand for and what is it used for?

• Wet and Dry used for protecting glass

• Water desiccant used to dilute water

• Water displacer, used to penetrate and lubricate siezed components

• Water droplets used to corrode mechanical components

Which of the following oil lubricates, penetrates and cleans for general use.

• 1 in 3 oil

• 31 oil

• 3x1 oil

• 3 in 1 oil,

What is this equipment used for?

• checking tracking

• checking Camber

• Checking head light aim

• checking bonnet alignment

State two faults that should be checked on this tool

• Gone soft and bent

• Bent and twisted

• Splits on head and blunt tip

• Head protrusion and twisted tip