Driver Control Program

Which of the following is NOT true of the Driver Control program on the IQ (2nd generation) Brain?

• It allows you to drive the BaseBot or Clawbot without any coding

• It has only one driver configuration possible, and you cannot make any changes to it

• It has the option to be run for only one minute or two minutes

• Buttons and joystick configurations can be changed by the driver

Which of the following best describes how you start running the Driver Control program once your Controller and Brain are connected?

• On the Brain’s Home Screen, use the check button to select the Controller icon. Then press the check button again to select Run.

• On the Controller, move the joysticks forward and backward, and press the A and B buttons concurrently.

• In VEXcode IQ, select ‘File’ and ‘Open Examples’. Then select ‘Driver Control program’.

Which of the following is NOT a driver configuration in the Driver Control program on the IQ (2nd generation) Brain?

• Split Arcade

• Left Arcade

• Penny Arcade

• Tank Drive

In the image below, the F Up and Down buttons will move the motor that is connected to which port on the Brain?

• 4

• 5

• 9

• 11

Which of the following best describes how to change the direction a motor is moving with the Controller buttons?

• On the Brain’s Home Screen, select the Controller icon, then toggle to select ‘Run 1 minute’ and press the check button.

• On the Brain’s Home Screen, select the Controller icon, then toggle to ‘Controls’ and select it. Then toggle to the button you’d like to change, and use the check button to select ‘Forward’ or ‘Reverse’ for that port.

• On the Brain’s Home Screen, select the Controller icon, then toggle to ‘Controls’ and Tank Drive.

Based on the image of the Control screen shown below, which of the following is TRUE?

• The Right Buttons will not control anything, because port 4 is disconnected

• The F Up and Down buttons are controlling the motor connected to port 1

• The Left Buttons are controlling the motor connected to port 10

• The Right buttons are set to move in Reverse direction

• Both A and C