Trial Test NACE 2 pt 2

You are working as an inspector in a galvanizing plant for the first time.

What are some of the hazards you need to be aware of :

• Risk of chemical exposure

• Risk of skin

• Risk of acid or caustic splashes

• All of the above

• None of the above

An Inspection and Test Plan is required when :

• It is always required

• When the Owner specifies one

• When the Inspector requests one

• When the Coating Applicator requests one

Coating Surveys are legally required :

• On commercial marine vessels and offshore platforms

• On high pressure gas lines and fireproofed structures

• On water tanks and potable water pipelines

• On food and beverage vessels and can linings

The cost of qualified Coating Inspection is normally offset by :

• Lower Application Costs

• Lower Supervision Costs

• Lower Coating Life Cycle Costs

• Lower Safety Enforcement Costs

When conducting inspections the Inspector should not follow which standards:

• NACE and SSPC standards in North America

• ISO standards in Europe and Asia

• Australian standards in Australia

• The specified standards

The coating applicator has ignored a enface preparation hold point and applied coating over the surface without a sign off from you as the inspector.

Your FIRST preferred course of action is to:

• Stop the job

• Require the Applicator to remove the coating

• Advise the Owner and write a Non-Conformance report

• Ignore the situation

From a corrosion perspective, the main difference between Ferrous and Non-Ferrous Metals is :

• Cost

• Iron Content

• Appearance

• Safety

When environmental enclosures are being used an inspector needs to be concerned about :

• Lighting

• Air Changes

• Structural Integrity

• All of the above

• None of the above

When observing design defects the NACE Inspector should :

• Stop the job immediately

• Ignore the defect as the inspector can’t change the design

• Request that the item be rebuilt with a better design for coating

• Document the defect and the potential problems that could result

A true or false question :

WJ-1 is always performed using UHWJ at pressures above 210 MPa (30,000 PSI)