IPv4 Configuration

What is the purpose of an IP address?

• To uniquely identify a device on the network

• To route traffic to a default gateway

• To configure DNS settings

• To assign a virtual IP address

What is the subnet mask used for?

• To determine the IP subnet a device belongs to

• To assign a unique address to a device

• To route traffic outside of the local subnet

• To configure DNS settings

What is the purpose of a default gateway address?

• To send traffic outside of the local subnet

• To uniquely identify a device on the network

• To configure DNS settings

• To assign a virtual IP address

What is the loopback address used for?

• To reference the local machine

• To determine if the IP stack is working properly

• To assign a unique address to a device

• To route traffic to a default gateway

What is the range of reserved addresses in IPv4?

• 240.0.0.1 - 254.255.255.254

• 127.0.0.1 - 127.255.255.254

• 169.254.1.0 - 169.254.254.255

• 192.168.1.1 - 192.168.1.165

What protocol is used to automatically assign IP addresses?

• DHCP

• DNS

• NTP

• ARP

What is an APIPA address?

• An automatically assigned IP address when DHCP is not available

• An IP address used for DNS configuration

• An IP address used for routing outside of the local subnet

• An IP address assigned to a virtual machine

What is the purpose of a virtual IP address?

• To assign an internal IP address to a logical network adapter

• To uniquely identify a device on the network

• To configure DNS settings

• To route traffic to a default gateway

What is the maximum value in each group of an IPv4 address?

• 255

• 0

• 1

• 256

What is the purpose of an ARP request?

• To check if an IP address is already in use

• To assign a unique address to a device

• To route traffic outside of the local subnet

• To configure DNS settings