ICT 9 M1 W1-2 4TH QUARTER

Which tool is used for installing and removing screws in the computer unit?

• Pliers and tweezers

• Screw drivers

• Soldering iron

• Anti-static wrist strap

What is the purpose of a LAN Tester?

• To connect terminals in the power supply

• To test the network connection

• To troubleshoot computer systems

• To clean optical media

What is the correct protocol commonly used in networks today?

• TCP/IP

• UDP

• NetBEUI

• IPX/SPX

What is the purpose of a crimping tool in network troubleshooting?

• To crimp the RJ45 connector to the UTP cable

• To test the network connection

• To clean optical media

• To connect terminals in the power supply

What should you do if the network cable is not properly connected to the computer?

• Use a soldering iron

• Install additional network cards

• Check the firewall settings

• Verify connections / LEDs

What is the purpose of thermal paste in computer systems?

• To test network connections

• To connect terminals in the power supply

• To dissipate heat from the processor

• To clean optical media

What is the correct IP address format?

• 102.55.92.1

• 255.255.255.192

• 192.168.1.1

• 127.0.0.1

What is the correct way to specify an IP address in TCP/IP protocol?

• Click Start / Settings / Control Panel

• Enter the IP address and Subnet Mask address

• Use a LAN Tester

• Install additional network cards

What should you do if the network card is not receiving a signal?

• Install additional network cards

• Use a soldering iron

• Verify connections / LEDs

• Check firewall settings

What is the purpose of an anti-static wrist strap, mat, and spray?

• To clean optical media

• To eliminate electrostatic discharge

• To test network connections

• To connect terminals in the power supply