(GSIUR Regulations) Part C and D Mock Exam

Why must no person install a meter unless the installation is so placed as to ensure there is no risk of damage to it from electrical apparatus?

• To prevent theft

• To ensure the meter is visible

• To avoid risk of electrical damage and ensure safety

• To make maintenance easier

According to Regulation 12(4), where should a meter be installed?

• In a hidden location

• In a readily accessible position for inspection and maintenance

• In the attic

• In a locked room

What must be done immediately after installing a meter and associated gas fittings?

• Paint the meter

• Adequately test and examine to verify gas tightness and compliance with regulations

• Leave it for 24 hours before use

• Cover it with insulation

Which of the following is NOT a requirement under Regulation 14(2) for supplying gas from a gas storage vessel to service pipework or gas fittings?

• A regulator installed to control the nominal operating pressure

• Adequate automatic means for preventing over-pressure

• Adequate alternative automatic means for preventing over-pressure

• Manual monitoring of gas pressure every hour

Why does Regulation 16(1) prohibit the installation of a prepayment meter as a primary meter where gas is passed on to a secondary meter(s)?

• Because if the prepayment meter runs out, it would cut off gas supply to all consumers on the system, leading to a potential risk of gas escape.

• Because prepayment meters are more expensive.

• Because secondary meters are not compatible with prepayment meters.

• Because it is difficult to read the meter.

Suppose a person modifies an existing gas system so that more than one primary meter is supplied from a service pipe. What must this person do according to the regulations?

• Ensure a permanent notice is displayed indicating that more than one primary meter is provided with gas through that service pipe or pipework.

• Remove all secondary meters.

• Install a new gas appliance.

• Notify all residents in writing.

According to Regulation 16(3)(b), what must be ensured when removing a meter if there is no service valve as mentioned in sub-paragraph (a)(i)?

• Ensure that the service pipe or service pipework is disconnected as near as is reasonably practicable to the main or storage vessel and that any part of the pipe or pipework which is not removed is sealed at both ends with the appropriate fitting.

• Leave the service pipework open for inspection.

• Only disconnect the meter and leave the pipework untouched.

• Seal only one end of the pipework.

What is the main purpose of Regulation 17 regarding secondary meters?

• To require a line diagram showing the configuration of all meters, installation pipework, and emergency controls to be prominently displayed.

• To ensure that only gas suppliers can install secondary meters.

• To mandate regular inspection of all secondary meters.

• To require landlords to remove all secondary meters annually.

If a gas service pipe is covered by the Pipelines Safety Regulations (PSR), who is responsible for ensuring the action stipulated in regulation 16(3)(b) is taken?

• The dutyholder under PSR (the gas transporter)

• The property owner

• The local council

• The tenant

According to Regulation 17(2), what must a person do if they change the configuration of any meter, installation pipework, or emergency control?

• Notify the local council immediately

• Ensure the line diagram is amended to show the altered configuration

• Replace all meters with new ones

• Disconnect the gas supply permanently