Quiz-8

When configuring a switch for SSH access, what other command that is associated with the login local command is required to be entered on the switch?

• • enable secret password

• • password password

• • username username secret secret

• • login block-for seconds attempts number within*seconds*

Which two characteristics describe the native VLAN? (Choose two.)

• • The native VLAN traffic will be untagged across the trunk link.

• • This VLAN is necessary for remote management of a switch.

• • High priority traffic, such as voice traffic, uses the native VLAN.

• • The native VLAN provides a common identifier to both ends of a trunk.

On a switch that is configured with multiple VLANs, which command will remove only VLAN 100 from the switch?

• • Switch# delete flash:vlan.dat

• • Switch(config-if)# no switchport access vlan 100

• • Switch(config-if)# no switchport trunk allowed vlan 100

• • Switch(config)# no vlan 100

A network contains multiple VLANs spanning multiple switches. What happens when a device in VLAN 20 sends a broadcast Ethernet frame?

• 
  

• • All devices in all VLANs see the frame.

• • Devices in VLAN 20 and the management VLAN see the frame.

• Only devices in VLAN 20 see the frame.

• • Only devices that are connected to the local switch see the frame.

What happens to switch ports after the VLAN to which they are assigned is deleted?

• • The ports are disabled.

• • The ports are placed in trunk mode.

• • The ports are assigned to VLAN1, the default VLAN.

• • The ports stop communicating with the attached devices.

Port Fa0/11 on a switch is assigned to VLAN 30. If the command no switchport access vlan 30 is entered on the Fa0/11 interface, what will happen?

• • Port Fa0/11 will be shutdown.

• • An error message would be displayed.

• • Port Fa0/11 will be returned to VLAN 1.

• • VLAN 30 will be deleted.

Which command displays the encapsulation type, the voice VLAN ID, and the access mode VLAN for the Fa0/1 interface?

• • show vlan brief

• • show interfaces Fa0/1 switchport

• • show mac address-table interface Fa0/1

• • show interfaces trunk

A high school uses VLAN15 for the laboratory network and VLAN30 for the faculty network. What is required to enable communication between these two VLANs while using the router-on-a-stick approach?

• • A multilayer switch is needed.

• • A router with at least two LAN interfaces is needed.

• • Two groups of switches are needed, each with ports that are configured for one VLAN.

• • A switch with a port that is configured as a trunk is needed when connecting to the router.

What type of VLAN should not carry voice and network management traffic?

• • data VLAN

• • voice VLAN

• • management VLAN

• • security VLAN

Which two statements are correct with respect to SVI inter-VLAN routing? (Choose two.)

• • Switching packets is faster with SVI.

• • There is no need for a connection to a router.

• • Virtual interfaces support subinterfaces.

• • SVIs can be bundled into EtherChannels.