Nurseries for full-time care of children under kindergarten age, hospitals, sanitaria, nursing homes with non-ambulatory patients, and similar buildings each accommodating more than five persons.

Education and Recreation

A “Two-Hour Fire-Resistive Occupancy Separation” shall be of not less than two-hour fire-resistive construction. All openings in such separation shall be protected by a fire assembly having a ____ hour fire-resistive rating

Assembly Occupant Load 1000 or More

Storage and Hazardous

Schedule of Principal, Accessory and Conditional Use/Occupancy of Building/Structure

It is a low-density residential zone, characterized mainly by single-family, single detached dwellings with the usual community ancillary uses on a neighborhood scale, such as executive subdivisions and relatively exclusive residential communities which are not subdivisions.

It is a medium density residential use or occupancy, characterized mainly as a low-rise single attached, duplex or multi-level

Structures on campuses or its

component parks/open spaces

and all other kinds of recreational or assembly buildings/structures on campus

such as auditoria, mess halls,

seminar facilities, gymnasia,

stadia, arenas and the like are under which Division.

The total width of all openings in any three-hour fire-resistive occupancy separation wall in any one-storey shall not exceed ______ of the length of the wall in that storey and no single opening shall have an area greater than 10.00 sq. meters.

The total width of all openings in any three-hour fire-resistive occupancy separation wall in any one-storey shall not exceed 25% of the length of the wall in that storey and no single opening shall have an area greater than _____ sq. meters.

Eaves over required windows shall not be less than _____ millimeters from the side and rear property lines.

When openings in exterior walls are required to be protected due to distance from property line, the sum of the areas of such openings in any storey shall not exceed ______ of the total area of the wall in that storey.

For medium density residential ______ uses or occupancies, a firewall can be erected on a maximum of 80% of the total length of a side property line.

For medium density residential (R-2) uses or occupancies, a firewall can be erected on a maximum of ____ of the total length of a side property line.

For a R-3 use or occupancy with a firewall on two (2) sides, a firewall can be erected on a maximum of _____ of the total length of each side property line; provided that all firewall construction shall not exceed 65% of the total perimeter of the R-3 property.

For a R-3 use or occupancy with a firewall on two (2) sides, a firewall can be erected on a maximum of 85% of the total length of each side property line; provided that all firewall construction shall not exceed _____ of the total perimeter of the R-3 property.

Building Height Limit for R-4 (Meters above highest grade).

Building Height Limit (BHL) by Type of Use or Occupancy

The size of an average automobile (car) parking slot must be computed at _____ meters by 5.00 meters for perpendicular or diagonal parking and at 2.15 meters by 6.00 meters for parallel parking.

A standard truck or bus parking/loading slot must be computed at a minimum of ______ meters by 12.00 meters.

A jeepney or shuttle parking/loading/unloading slot must be computed at a minimum of 3.00 meters by ____ meters.

Minimum Required Parking Slot for Division H-4 is one (1) slot for every ______ sq. meters of gross floor area

Multi-floor parking garages may serve the 20% parking requirements of the building/structure within 200.00 meter radius, provided at least ______ of the parking requirements are complied with and integrated in the building design.

For Basic R-2 and Basic R-3 uses or occupancies (for single family dwelling units only), up to 50% of the _______ abutting the RROW may be paved/hardscaped.

Wake chaplets with a minimum area of 50.00 sq. meters for thirty (30) persons and at least _____ sq. meters for each additional person may be provided.

Reference Table of Floor to Lot Area Ratio (FLAR)

Designations/ Rights

Multiplier to Convert the GFA to TGFA for Commercial 3

Conversion Table of Gross Floor Area (GFA) to Total Gross Floor Area (TGFA)

Reference Table of Maximum Allowable PSO, Maximum Allowable ISA, the MACA,

the Minimum USA and the TOSL by Type of Land Use Zoning per Lot

Table VIII.1. What is the PSO for R2 Max. with fire wall?

Required open space for Through Lot.

Table VIII.1. What is the PSO for C1 no fire wall?

Required open space for Corner Lot abutting 3 or more streets, alleys, etc..

Table VIII.1. What is the PSO for Industrial 1 no fire wall?

Table VIII.1. What is the PSO for C1 with fire wall?

Full form of TOSL

Absolutely no abutments are allowed at any property line for any R-1 lot type/location.

Abutments shall be allowed on 2 sides for any R-2 lot type/location. There shall be no firewalls/abutments on the front and rear property lines for any R-2 lot type/location.

Abutments shall be allowed on two (2) sides only for any ____ lot type/location. There shall be no firewalls/abutments on the front and rear property line for any ____ lot type/location.

Reference Table for Minimum Setbacks for Residential Buildings/Structures

Table VIII.2. Minimum Setbacks for R1

All inner courts shall be connected to a street or yard, either by a passageway with a minimum width of 1.20 meters or by a door through a room or rooms.

Table VIII.2. Minimum Setbacks for R2 max

For buildings of more than two (2) storeys in height, the minimum width of the rear or side court shall be increased at the rate of _____ millimeters for each additional storey up to the fourteenth (14th) storey

A carport shall be considered part of the Total Open Space within Lot (TOSL) particularly if it is entirely roofed or roofed with overhangs. In such a case, it must be counted as an integral component of the Allowable Maximum Building Footprint (AMBF).

Habitable rooms provided with artificial ventilation shall have ceiling heights not less than _____ meters measured from the floor to the ceiling

Head-room clearance of not less than ______ meters above the finished floor.

Mezzanine floors shall have a clear ceiling height not less than ____ meters above and below it

Sizes and Dimensions of Rooms. Rooms for Human Habitations ____ sq. meters with a least dimension of ____ meters

Toilet and bath rooms, laundry rooms and similar rooms shall be provided with window or windows with an area not less than ____ of the floor area of such rooms, provided that such opening shall not be less than 240 sq. millimeters.

There shall absolutely be no openings on/at/within/through all types of abutments (such as firewalls) erected along property lines except for permitted vent wells. This Rule strictly applies to all new and existing developments.

Table VIII.G.1. Easement* Along Water Bodies/Way by Location. Urban Areas ____ meters per side of waterway (Fig.VIII.G.3.)

Table VIII.G.1. Easement* Along Water Bodies/Way by Location. Agricultural Areas ____ meters per side of waterway (Fig.VIII.G.3.)

Table VIII.G.1. Easement* Along Water Bodies/Way by Location. Forest Areas ____ meters per side of waterway (Fig.VIII.G.3.)

Minimum Road Right-of-Way (RROW) Provisions for Developments with Multiple Dwelling Units

The minimum width of the sidewalk for a RROW width of 9.00 meters or more shall be _____ meters on each side of the RROW.

Range of Required Sidewalk and Planting Strip Widths (total at both sides of RROW) by RROW Width

Minimum Planting Strip Widths by RROW Width

The sidewalk pavement shall have a non-slip surface and shall slope down from the building line towards the curb line at not more than 1/50 and shall level off with the curb. (Fig. VIII.G.14.)

Suggested Minimum Lot Sizes, Lot Dimensions and Types by Use or Occupancy

Courts, yards, and light wells shall be measured clear of all projections from the walls enclosing such wells or yards with the exception of roof leaders, wall copings, sills, or steel fire escapes not exceeding ____ meters in width.

Eaves, canopies, awnings (or media agua) over required windows shall not be less than ___ millimeters from the side and rear property lines.

There shall absolutely be no openings on/at/within/through all types of abutments (such as firewalls) erected along property lines except for permitted vent wells. This Rule strictly applies to all new and existing developments.

The bottom of the window opening should not be more than ____ millimeters from the floor.

Vent Shafts. The openings to the duct or intake shall be not less than ______ millimeters above the street surface or level of court.

If wider than _____ meters, the easement may include a roadway/carriageway component on which vehicles can pass or on which the same may temporarily park, e.g., an esplanade and the like.

No obstruction should exist within the RROW/access streets servicing multiple housing of more than ____ units.

Minimum Width of Sidewalk for Seven (7) up to fifteen (15) Number of Dwelling Units.

Combined open and arcaded sidewalks shall be provided with a planting strip of not less than

800 millimeters in width up to a maximum of _____ of the allowed sidewalk width, as a separating strip between the arcaded portion and the open portion of the sidewalk.

When the grade of two (2) connecting sidewalks are between 1/10 and 1/8, the two sidewalks shall be joined by means of a ramp having any convenient slope not exceeding ______.

Entrance and exits ramps shall have a slope not exceeding _____.

Mountable curbs shall only be allowed if the sidewalk width on each side of the RROW is at a minimum of ______ meters wide.

Type of lot which has Minimum Lot Sizes, Lot Dimensions of 400.00 sq. meters , 16.00 meters (w) x 25.00 meters (d) for R3 max.

Courts, yards, and light wells shall be measured clear of all projections from the walls enclosing such wells or yards with

the exception of roof leaders, wall copings, sills, or steel fire escapes not exceeding ____ meters in width.

Maximum ISA for Ind-1.

A primary or main natural light and ventilation shaft (vertical) with a clear distance of at least 3.00 meters shall be located at the center of the building and shall traverse the entire combined height of the building above and below grade as shown in Fig. ______.

Sidewalks of different levels shall be joined by means of a ramp having any convenient slope not exceeding _______.

Required windows may open into a roofed porch where the porch has one of the longer sides at least ___ open and unobstructed.

1. What is the recommended slope for entry and exit ramps for vehicles?

What is the maximum allowed slope of entrance and exit ramps?

What is the minimum required parking slot for bowling alleys?

What is the minimum unobstructed cross-sectional area and the minimum dimension of an air duct or intake?

No obstruction should exist within the RROW/access streets servicing of how many housing units?

The minimum clear height for the utilization of air rights above RROW shall be how many meters from the finished crown elevation of the roadway/carriageway?

Under PD1096, basement can only be constructed if the lot is being serve by RROW with a minimum width of how many meters?

No building shall be constructed unless it adjoins or has direct access to a public space, yard or street/road on at least how many of its sides?

The wind load for roofs should be at least how many kilograms per square meter vertical projection?

Habitable rooms provided with artificial ventilation shall have ceiling heights not less how many meters measured from floor to ceiling.

What is minimum room size for human habitation and what is the least dimension of wall?

What is the total minimum width of sidewalk for a 9.00 meters RROW ?

1. Eaves, canopies, awning (or media agua) over required windows should not be less than how many millimeters from the side and rear property lines.

In case of sloping grade where the edges of the building footprint (AMBF) running perpendicular to the RROW has a difference in elevation of more than , the average grade level of the building footprint (AMBF) shall be considered the established grade elevation.

Direct access of parking/loading/utility slots and terminals to the RROW shall be generally disallowed to prevent the usage of the RROW as a area.

Administrative Office - a lot shall be allocated for an administration building office for memorial parks with an area of above one (1) hectare.

Traffic generating buildings such as shopping malls or similar facilities that have very high volumes of pedestrian and vehicular traffic may be located at major intersections or within 100.00 meters of such intersections, provided that the distance between the street curb of the ingress/egress of such a commercial lot/property (nearest the intersection) and the straight curb of the intersection shall not be less than .

A chapel with a floor area of at least shall be constructed at a convenient location within the cemetery where funeral ceremonies may be held, and incidentally serve as haven for funeral participants against sun and rain.

Ventilation or vent shafts shall have a horizontal cross-sectional area of not less than 1.00 sq. meter for every meter of height of shaft but in no case shall the area be less than _______. No vent shaft shall have its least dimension less than

Air ducts shall open to a street or court by a horizontal duct or intake. Such duct or intake shall have a minimum unobstructed cross-sectional area of not less than ___________ with a minimum dimension of 300 millimetres. The openings to the duct or intake shall be not less than 300 millimetres above the street surface or level of court.

If wider than __________ meters, the easement may include a roadway/carriageway component on which vehicles can pass or on which the same may temporarily park, e.g., an esplanade and the like

Maximum allowed PSO for basic R3 with firewall?

The following are allowed as customary uses in a R3 zone but one:

Easement along bodies of water in urban areas is:

In computing for parking slots, a fraction of ____ and above shall be considered as one car parking slot to be provided.

A height clearance certificate shall be secured from the Air Transportation Office before building permit may be issued for the construction of building/structures located within ____ radius of the runway ends of an aerodrome regardless of height.

For larger developments and traffic generating buildings as well as parking structures, what is the minimum distance should be the standard to be considered?

Building height limit of PUD at an inland area in meters above highest grade is?

The floor areas herein above provided maybe increased in certain specific instances and under appropriate conditions, based on existence of public space, yards extending along and adjoining two or more sides of the building or structure subject to the approval of the?

Under PD 1096 what is the minimum width for Transitional area (Buildable) but requiring A.T.O clearance of airport runway approach/departure surface?

Units located in townhouse (R-4) building structures regardless of number storeys. What is the minimum required parking slot, parking area and loading space requirements with a gross floor area of ____sq. meters provide ____ pooled parking slot* for every two units or fraction thereof?

Under PD 1096, Airport runway minimum clearway clearance from inner edge/airstrip to runway surface within approach departure zones is?

Indigenous family dwelling units; privately owned at least one car parking slot*, for every how dwelling units and which shall be provided outside of the RROW?

Number of allowable storeys/floors above established grade for R5 _____.