Font size
WorksheetsKoop Table Saw Safety
Total questions: 23
Worksheet time: 21mins
How high above the workpiece should the saw blade be set?
As high as it can go
1 full tooth
2 teeth
no more than 3 teeth
All table saw adjustments should be made:
While the saw is in motion
Only when the saw is turn off.
It depends on which type of blade you're using.
After the fence has been removed from the table.
When ripping long stock you should:
Have a helper to assist the stock, but not to pull it.
Use an outfeed table and roller
Press down hard to support the stock and allow it to fall to the floor once it's passed the blade
Ripping of long stock should only be done with a sled.
Is it safe to saw defective stock, warps and any foreign material?
Sure, cut it like it is.
No, remove foreign material or knots first
The Riving knife shall be used when:
Cutting tapers
Crosscutting
Cutting rabbits or dadoes
All times that its possible
When ripping a board you should not_____ a board until is it completely past the blade.
Release
Repeat
Cut
Throw
Before using the table saw you need the instructor's permission and proper training
True
False
Identify Part B
Miter Gauge
Power Switch
Blade Guard
Table
Identify Part C
Fence
Tilt Hand Wheel
Miter Gauge
Blade Guard
Identify Part A
Blade Guard
Table
Miter Guage
Elevation Hand Wheel
Identify Part D
Blade Guard
Power Switch
Fence
Miter Gauge
Identify Part E
Elevation Hand Wheel
Tilt Hand Wheel
Power Switch
Miter Gauge
Identify Part F
Elevation Hand Wheel
Tilt Hand Wheel
Power Switch
Miter Gauge
