Font size
WorksheetsRBC level1 ECA
Total questions: 25
Worksheet time: 13mins
Safety Glass should be labeled
made in USA
made in China
z 87
close your eyes while wearing
Before plugging in a power tool
be sure the tools guards work
be sure the tool is in the off positio
check the condition of the tool
all of the above
Never use an Extension cord that _________
has a ground plug cut off
are in standing water
is cracked
all of the above
You always check guards before using a machine
True
False
PPE stands for
personal protective equipment
please protect everyone
practical protection environment
protecting people endangered
Never cross your hands over the work piece ?
true
False
After cutting Always lift the saws blade up completely before releasing the power tigger
true
false
Which direction should you slide the machine when cutting?
Slide out, push down and push away from your body
Push down and pull toward your body
Make sure the blade is not touching the wood before the machine is turned on.
true
false
What PPE ( personal protective equipment ) must be worn when operating the slide saw
gloves
Hard hat
steel toed shoes
safety glasses labeled z87
How high above the workpiece should the saw blade be set?
As high as it can go
1/8"-1/4"
2 3/8" - 9 5/8"
When ripping long stock, you should:
Push it halfway through then reverse it to complete the cut.
Push it halfway through, and then walk around to the rear of the table and finish pulling it through.
Push the stock fully through the saw and onto and outfeed table, use roller stands or ask for assistance from another person.
When operating a table saw, you should stand:
To the right side of the blade if possible
o the left side of the blade.
Directly in line with the blade.
Not in direct line of the blade.
When ripping long stock you should:When ripping long stock you should:
Have a helper to assist the stock, but not to pull it.
Press down hard to support the stock and allow it to fall to the floor once it's passed the blade
Ripping of long stock should only be done with a sled.
When is it safe to do freehand (no fence, no miter gauge) sawing on the table saw?
When cutting circles
Cutting very thin stock
never
All table saw adjustments should be made:
While the saw is in motionWhile the saw is completely stopped.It depends on which type of blade you're using.After the fence has been removed from the table.
While the saw is in motion
While the saw is completely stopped.
It depends on which type of blade you're using.
After the fence has been removed from the table.
The portable circular saw blade should extend through the material being cut by _____________ inches.
1/8
1
2
4
Material should be well supported when being cut with the portable circular saw to __________________________.
Keep it from falling over.
So the cut can be made quickly
To prevent damaging the material.
To prevent binding the saw blade and causing a kickback.
Before putting the saw down after a cut has been made _________________________________.
Unplug the saw.
Make sure the cover is over the blade.
Make sure the blade has stopped rotating
always check the the operation of the blade guard before using the saw or any machine that has a blade guard
true
false
how many 16 ths are in an inch
(a)
how many 1/8 ths are in an inch
(a)
what plan would you find the sizes of a houses rooms
(a)
what plan would you find the the size of a foundation
(a)
what plan would you find what the font of the house looks like
(a)
