WorksheetsInterior Trim
Total questions: 20
Worksheet time: 20mins
Full rounds, half rounds and quarter rounds are classified by their ____.
use
shape
Location of use
application
A molding applied at the bottom of a wall is ____.
crown
casing
apron
base
A molding placed around windows and doors is called ____.
door tim
crown molding
casing
full round
A part of window trim is ____.
apron
stools
stops
all of the above
Joints on exterior corners are ____.
mitered
coped
square cut
lapped
Joints on interior corners are usually ____.
mitered
coped
square cut
lapped
The most common angle cut on a miter box is ____.
45 degrees
30 degrees
22 1/2 degrees
35 degrees
Molding should be positioned in the miter box ____.
loosely
face side up
face side down
backside up
Miter cuts are made with ____.
all of these saws
miter box
table saw
radial arm saw
The first step in coping the end of a molding is to ____.
square cut the end
make a front miter on the end
make a back miter on the end
make a face cut on the end
A coped joint is cut with a ____.
coping saw
hand saw
hack saw
back saw
Coped joints will ____.
not need to be fastened with nails or adhesive
will not open up when nailed
make an exterior corner fit perfectly
all of the above
Moldings applied around the door opening are called ____.
base shoe
base cap
door casing
window trim
Door casings must be installed ____.
all the way to the floor
before base molding is installed
to cover the opening between the jamb and the wall
all of the above
The setback of the trim from the edge of the jamb is called the ____.
reveal
set back
set edge
head set
The order of installation of window trim is ____.
stool cap, apron, jamb extensions, and
casings
apron, jamb extensions, stool cap, and
casings
casings, jamb extensions, apron, and
stool cap
jamb extensions, stool cap,
casings, and apron
To keep the molding from splitting at the end, ____.
keep the nails 2 to 3 inches away from
the end
blunt the pointed end of the nail
drill a hole slightly smaller than the nail diameter
all of the above
The setback of the trim from the edge of the jamb is called the ____.
reveal
set back
set edge
head set
The molding that covers the joint between the window sill and the wall is the ____.
stool cap
stop
window casing
apron
Moldings applied around the door opening are called ____.
base shoe
base cap
door casing
window trim
