The technician bleeds the power steering system by

The end of the steering gear sector shaft, which is located outside the housing, has splines that attach to the

The Average automotive power steering hydraulic pump has a MAXIMUM output pressure of

When diagnosing electronic variable steering, Technician A states that the output is usually located in the power steering pump or gear. Technician B states the steering rate(effort) is highest at low speeds. Which Technician is correct?

The center part of a wheel is called

The wheel spins smoothly do to the presence of___________ in the hub

Bearings reduce the force of

Friction is a force of that resist

The common bearing consist of

Technician A says that when adjusting a manual steering gear, selector lash should be set first. Technician B says that worn bearing preload should be adjusted last. Which technician is correct?

When lubricating the front suspension,

If a front wheel has radial movement, but the ball joints check good, what would be the most likely cause?

When a front inner wheel bearing is pitted, the technician should replace the

When diagnosing electronic suspension, Technician A states that all non-electronic concerns must be repaired first. Technician B states that scan tools may be used to obtain DTCs. Which technician is correct?

When you are only paid for the hours you work, you make _______

A brake pedal that slowly goes to the floor when the brakes are applied, with the engine off, with no fluid loss could indicate the

If all four wheels tend to slowly lock up while driving, the most likely trouble would be in the

When replacing the left front caliper on a diagonally spilt brake system, the correct bleeding sequence is

If all four wheels tend to slowly lock up while driving, the most likely trouble would be in the

When replacing the left front caliper on a diagonally spilt brake system, the correct bleeding sequence is

When turning a scored brake drum, the maximum oversize limit for MOST automobiles would be

The number 10.090 cast into the brake drum refers to the

When using a brake drum lathe, the technician should always use

The type of disc brake calipers found on most American automobiles is

A disc brake rotor's total indicated runout reading should be

When checking for parallelism on a disc brake rotor, the technician should use a

For lateral runout, a technician should use a

A high hard brake pedal and excessive stopping distances could indicate.

Vacuum-assist power brake units have __________reserve stops

Vacuum-assist power brake units have __________reserve stops

When using manufacturer's diagnostic routines for traction control,

When following a manufacturer's diagnostic routine, which of the following is correct?

When using manufacturer's diagnostic material, it is TRUE that

What component is the heart of the anti-lock brake system (ABS)?

An ABS system will

When diagnosing traction control, Technician A states that the anti-lock brake system must be working correctly before traction assist can be diagnosed. Technician B states that the anti-lock system may use engine management system components. which technician is correct?