WorksheetsSound Engineering Final Exam
Total questions: 25
Worksheet time: 2hrs 5mins
The range of frequencies detectable by the human ear is:
20 Hertz to 25,000 Hertz
20 Hertz to 20,000 Hertz
30 Hertz to 30 kHz
None of the above
What is the name if this type of microphone?
Condenser mic
Capacitor mic
Dynamic Mic
None of the above
The voltage that is supplied either by a battery in the mic or by external is called:
Phantom Power
Battery Power
Electricity Power
None of the above
The _______________________mic uses a special type of capacitor which has a permanent voltage built in during manufacture
dynamic mic
electret condenser
capacitor mic
none of the above
What is the name of this polar pattern:
Cardiod
Omni
Bi-direction
None of the above
What is the name of this polor pattern
Omni-directional
Cardioid
Figure 8
None of the above
What is the name of this polar pattern:
Cardiod
Figure 8
Hyper Cardioid
None of the above
What is the name of this polar pattern:
Hyper Cardiod
Figure 8
Cardioid
None of the above
_____________________ refers to the way a microphone responds to different frequencies
Frequency response
Polar patterns
Cardioid
None of the above
What is the name of this chart:
Decibel count chart
Frequency response chart
All of the above
None of the above
Full range speakers are __________________ systems incorporating woofer and ________________ (and if used, __________________) drivers in single enclosure.
High pass filter
integrated, tweeter, midrange
Low pass filter
None of the above
This describes the microphone's sensitivity to sound from various directions:
Crossovers
Microphones
Directionality
None of the above
Frequency is measured in:
White Noise
Hertz
Centimeters
None of these
Select Audio Effects from the list
Delay
MIDI Instrument
Volume control
Reverb
EQ
Why is mixing important?
To enable you to produce balanced and consistent audio
To enable you to finish a project
To enable you to record MIDI instruments
To enable you to make your audio files louder
Why are active speakers generally heavier than passive speakers?
They are of better Quality
They're made out of heavier materials
They have a amplifier built in to the speaker, adding more weight
They cones of the speakers are lighter in a passive speaker
________________________is a device which takes two or more audio signals, mixes them together and provides one or more output signals.
Keyboard
Direct Inject Box
Mixer
None of the above
_______________________ channels are a way to send a "copy" of the channel signal somewhere else.
auxiliary
equalization
mixers
None of the above
A group of knobs, buttons, and a fader used to control one item like a microphone is called a _______
Monitor
Channel
Group
Sub
One end plugs into the mixing board. What does the other end plug into?
Microphone
Monitor
XLR
Sound board
The circled part of the image is...
The volume fader
The level meter in DBFS
The peak level showing the signal clipping
The amount of panning applied to the sound
What is best the definition of a microphone?
A microphone is a device used to collect sound
A microphone is a transducer that captures audio waves and converts them into an electrical signal
A microphone is just a speaker working in reverse
A microphone needs 240volts to be able to work and capture sound effectively
Devices and software which allow the manipulation of the signal in various ways:
Amplifiers
Eq's
Signal Processors
None of the above
