Toggle are basically _________ in nature, that will change its contact when pressed and will NOT return back to its initial state upon release.

The contact of this switch is NORMALLY ______.

The contact of this switch is NORMALLY ______.

Identify this type of switch.

Identify this type of switch.

Identify this type of switch.

Identify this type of switch.

Identify this type of switch.

Identify this type of switch.

In the limit switch shown in the picture, identify the name of the part labeled with number 1?

When the valve reaches the its desired position, what will be the position of the correctly set limit switch?

In limit switches, it is the distance or angle that the actuator must go through to trip the contacts.

A part of limit switch containing the electrical contact mechanism.

The component containing the terminal screws or screw/clamp assembly necessary for wiring purposes.

_________ limit switches are often chosen for their precise operating abilities, small size and low cost.

This type of switch is _____ pole, _____ throw.

Automatically operated switches can be operated by process variables such as flow, level, temperature and pressure.

Mercury switches are replaced by REED switches due to __________ hazards.

The ________ refers to the number of complete circuits that can pass thru the circuit at one time.

The OPENING of contact in a switch is called ________.

The CLOSING of contact in a switch is called ________.

REED relay contacts are activated by external __________.

A _________ switch uses changes in level of a liquid to open and close the contact.

In a pressure switch, the ________ spring is used to set the differential values.

Identify the following part of a pressure switch.

_______ switch are used to convert mechanical motion into an electrical signal and limit the actions of the process.

A rod level limit switch is also called ________.

This type of switch is _____ pole, _____ throw.

This type of switch is _____ pole, _____ throw.

_________ switch is a manual switch that is used to reverse the rotation of motors.

Which of the following is NOT a type of interlocking.

A __________ is a bank of normally close and normally open switches that are controlled by a single lever or handle.

What type of interlocking provides electrical isolation of the opposing energized coil?

What type of limit switch actuator is used on limit switches with maintained contact switching?

Load that the switch can handle without making or breaking the load.

When a switch will make or break, an ________ will then occur across the contacts which will tend to heat and burn them.

________return limit switches have no spring return mechanism, it relies on its weight to return it to its free position

The position of the actuator at which the contacts return to their original state

Ability of a switch to repeat its characteristics precisely from one operation to the next operation