NEW
Font size
WorksheetsCarp 1 27103 RQs & TT
Total questions: 25
Worksheet time: 13mins
The most accurate level is the _____.
Torpedo level
Water level
Carpenters level
Line level
Antilaser eyewear should be worn when a laser level's output is greater than _____.
5mW
8mW
10mW
2mW
The type of square that is only useful for marking angles at 90 degrees to the edge is called a _____.
speed square
try square
combination square
framing square
The plane used to true long boards such as the edge of a door is known as a _____ plane.
jack
jointer
block
smoothing
The handsaw used to make very fine cuts for joinery is called the _____.
Back saw
The Advisory Committee
compass saw
Dovetail saw
The amount of material removed by the blade of a saw during a through cut is called the _____.
kerf
cut
dado
A cut that is made across the grain at an angle other than 90 degrees is called a(n) _____.
bevel
miter
angle
dado
The size of a table saw is determined by _____.
The size of the fence
The largest-sized blade it will take
The measurement of the table
The degree of bevel it can cut
Which of the following tasks is not commonly done with a power plane?
Chamfering
beveling
cross cutting
straightening
A nailer or stapler that is powered by compressed air is called _____.
hydraulic
pneumatic
kinetic
cordless
One of the hazards associated with a table saw is the possibility of _____ as the stock gets pinched as it travels through the saw blade.
kickback
hard wood
sawdust
throwback
The _____ should be sharpened on a bench grinder to ensure smooth cutting.
chiselers
screwdriver
plane iron
flat iron
When cutting trim molding around a doorframe, you would most likely be performing _____.
bevel
chamfer
miter
slanted
If a long board has an imperfect edge, a jointer plane can be used to make it _____.
false
true
accurate
horizontal
_____ are formed when the tongue of a workpiece is fit into a rectangular cutout or opening on an adjoining piece.
butt joint
tongue in groove joint
mortise and tenon joint
tongue lap joint
Use a _____ to hold a door safely on edge when planing it.
door jack
plane stiffener
door jack-up
butt hinger
A cut that is made across the sloping edge or side of a workpiece at an angle of less than 90 degrees is known as a _____ .
bevel
miter
chamfer
dado
The installation of a strike plate and hinges in a doorjamb would require _____.
miter cuts
Pocket (Plunge) Cuts
chamfer cuts
dado cuts
When measuring, account for the amount of material removed by the saw blade, which is known as the _____.
smurf
kerf
blade shadow
cheetos
A _____ is a triangular joint often used to attach drawer fronts to the sides in antique furniture.
dove tail
fish tail
robin's tale
drawer tail
A cut made across the grain in lumber is known as a _____ .
dado
slash cut
cross cut
carpenter cut
A rectangular cut made along the edge or end of a board to receive another board is known as a _____ .
mortise cut
rabbet cut
tenon cut
dado cut
A _____ can be used to cut lumber at precise angles.
spider box
cereal box
soap box
miter box
The installation of crown molding often requires that wood be cut with both a bevel and a miter, which is known as a _____.
two-way cut
this way and that way cut
compound cut
doubled-up cut
For cabinet drawers, _____ should be cut in the sides, front, and back to receive the drawer bottom.
rabbet cuts
cold cuts
lined-up cuts
bottom cuts
