Font size
WorksheetsSolidWorks CSWA basics Vocabulary 2
Total questions: 18
Worksheet time: 5hrs 30mins
What Sketch Tools/Features allows you to copy an existing entity into a pattern?
Linear
Circular
Perpendicular
Isometric
What Feature can you use if there is no Plane or Planar face that can be used?
(a)
What are the requirements for your first sketch to be Fully Defined for making a feature?
Shaded sketch/ Fully closed
Some relation to the Origin
All black lines
A mixture of Blue and Black lines
What sketch tool can you use to copy and paste another Features Geometry into your current sketch?
Reference Geometry
Trim
Convert Entities
Extend
What makes the trim tool different from deleting?
There is no difference
It can get rid a specific area
It can add entities
What tool will copy the selected entities and move them a set amount?
(a)
What is the conversion from Radius to Diameter and visa-versa?
Radius is half the Diameter
There is no need for conversion, they are the same size
Diameter is two times the Radius
What even is a Radius and Diameter?
What tool/ feature will smoothen or round the edges of a sketch or feature.
Fillet
Chamfer
Mirror
Linear sketch pattern
What relation is used to seamlessly connect entities with a circular entities?
Coincident
Parallel
Horizontal
Tangent
Where do you find the mass of your part?
(a)
What are the two units that we use in this course?
IPS(Inches, Pounds, Seconds)
MMGS(Millimeters, Grams, Seconds)
CGS(Centimeters, Grams, Seconds)
MKS(Meters, Kilograms, Seconds)
What are the two options you see when dimensioning a Circle or Arc?
Length and Width
Radius and Width
Diameter and Length
Diameter and Radius
What view is this?
Isometric
Front/Back
Top/Bottom
Right/Left
Based on the isometric view in the upper right of the drawing, what view is shown in the upper left?
Top
Front
Back
Right
When making an angled plane with Reference Geometry, what is required?
Two References
One Reference
The Angle
The Length
The Width
What does the centerline in the middle of this sketch tell you?
There is symmetry between the sides
It tells us nothing about the sketch
There is a height dimension
What is a centerline!!
When a part has a dimension that has a something like "4 X R 0.75" or "R0.75 4PL.", what does that tell us?
That dimension is only in one location
The dimension is in 4 Locations
We are multiplying 0.75 by 4
When making a circular part that has a centerline giving it symmetry, what feature can be used?
Revolved Boss/Base
Extruded Boss/Base
Extruded Cut
Some Random Feature
