NEW
Font size
WorksheetsMotor Vehicle MV2 155 Mock
Total questions: 15
Worksheet time: 1hrs 15mins
What is the name of the inspection carried out before it is handed back to the customer?
Pre-work inspection
Post work inspection
Pre-delivery inspection
Maintenance inspection
Which one of the following would a customer request prior to the annual test on a five year old vehicle?
Pre-MOT inspection
Post work inspection
Pre-delivery inspection
Safety recall inspection
What can the equipment shown in the image be used to check?
Braking efficiency
Lighting efficiency
Steering alignment
Suspension alignment
What fault does the reading indicate in the image shown below?
Incorrect tracking
Distorted brake disc
Slight brake imbalance
Tyre pressures too high
Which one of the following MUST always be carried out following a vehicle inspection?
A full vehicle valet
Re-tune radio stations
Complete MOT documentation
Remove finger marks and VPE
Which of the following would indicate one seized piston in a fixed brake caliper?
Equal wear of the two pads
Uneven wear of the two pads
Excessive wear on the inside tyre tread
Excessive wear on the outside tyre tread
Under what engine operating condition should a diesel smoke test be carried out?
At idle speed when cold
At optimal operating temperature
At mid-engine speed range when cold
Engine speed when minimum boost occurs
Using the technical data shown, which one of the following camber readings are within specification?
1°20'
1°70'
2°50'
4°20'
Using the technical data sheet, what is the exhaust valve clearance for the 725 model?
0.14 mm
0.24 mm
0.30 mm
0.32 mm
Why is an inspection sheet used when inspecting a vehicle during a routine regular service?
It saves time using a job card
It is easier for costing purposes
It ensures the appropriate checks are made
It ensures the work is completed within the time scale
Which one of the following would be checked by aural inspection only, without the use of and additional equipment?
Brake discs
Wheel bearings
Broken coil spring
Work track rod end
Which one of the following would cause and engine to emit excessive black smoke from the exhaust?
Faulty air filter
Faulty piston ring
Faulty cooling fan
Faulty cylinder head gasket
Which of the following would cause a front tyre tread to wear excessively on the inner edges?
Positive camber
Negative camber
Under inflated tyre
Out of balance tyre
Which of the following faults could be caused by worn suspension dampers?
Poor vehicle acceleration
Increase in braking distance
Decrease in braking distance
Increased road spring oscillation
A technician needs to road test a car, which of the following is the most important consideration?
They hold the correct driver's licence for the vehicle
They ensure the work bay is tidy and all tools have been put away
They complete the job card with all details concerning the vehicle repair
They check the vehicle's tyre pressures, oil level and windscreen washer fluid
