When an interviewer judges an
interviewee, they are judging

Which of the following order is the most logical for the steps listed above

Return all equipment clean and in working order to the correct storage area. 

Never notify a teacher of any unsafe conditions you observe, just take care of it yourself.

Wear approved safety glasses (or side shields) whenever cutting materials, using power tools, operating mills or other equipment, or other tasks as required. NO exceptions to this rule.

This is the force that resists the motion of two surfaces in contact

There were several mentions during the design process of repeating certain steps multiple times until an acceptable result is achieved.  This act of repetition is known as “iteration.”

During this step is when the construction of the solution is started. In all steps but especially this one safety is a primary concern.

Which of the following is NOT a common mishap with electricity

The purpose of an interview is for the
employer to discover

These devices detect small changes in current and stop the flow of electricity. 

It is not necessary to clean your table at the end of the block, your teacher and janitor will clean up for you.

This step is commonly referred to as brainstorming. 

When responding an electrical emergency you should

When removing an electrical plug pull the cord. Report damaged electrical equipment immediately. Do not use damaged electrical equipment.

_______________________are types of materials that hold back the flow of electricity.

If equipment is broken or not working properly, tag-out the equipment and report the problem to your instructor immediately.

Also referred to as research.

Personal Protective Equipment (PPE) is your first line of defense against injury. Always wear PPE if required for a task.

Place hot tools such as soldering irons in their stand when not in use.

Always work alone. A teacher does not have to be present at all times during any activity involving tools, cutting devices, machinery or any equipment that involves a risk of physical injury.

Follow written directions. If you do not understand a procedure just use your best judgement and proceed.

When instructed, remember to unplug electrical equipment before leaving the room. Do not use extension cord in walkways without taping cords with gaffer’s tape or duct tape.

A property of matter by which it remains at rest or in uniform motion in the same straight line unless acted upon by some external force

Your work area should be as clean as possible at all times: clean as you work when possible. Keep aisles clear.

The design process is not a linear thing; it is common to jump from step to step.  

This step is generally the first step of the design process. The team will identify the problem and begin identifying constraints and specifications

Report any accident or injury to the teacher immediately, no matter how trivial it may seem. This includes strains, sprains, bruises, cuts, foreign material in the eye, and any other such occurrence.

Report missing covers, frayed wiring, and overloaded circuits to your _______________ immediately.

It is not necessary to read operating instructions thoroughly before beginning a project.

Objects are ____________________ if they are connected to the earth by a conductor.

This is defined as a condition that a solution to a problem must satisfy.  . restriction

When using sharp instruments, always carry them with tips and points pointing down and away from your body. Always cut toward your body.

In an interview, a job candidate will be
asked about their

___________________allow electricity to flow easily. 

This describes how well the finished solution must perform

Which of the following is a mistake while working around/with electricity

Handle heavy objects carefully. Never attempt to lift an object  that seems too heavy to you, by yourself: ask for help and team-lift the object to avoid back injury.

Conduct yourself in a responsible manner at all times. Horseplay, practical jokes and pranks are dangerous to you and your classmates and will not be tolerated.

It is ok to  sit on tables. 

When brainstorming, teams focus on the quality of ideas generated, not the quantity.  Only ideas that are known to work should be considered.

___________________ is a good conductor because it contains dissolved salts and minerals. Our bodies contain 70% and can therefore act as a conductor.

 It is ok to wander around the room, distract other students, or interfere with the projects of others.