Water from an individual water supply shall be approved as __________ by the authority having jurisdiction prior to connection to the plumbing system.

The maximum flow rate for a water closet is __________ gallons per flushing cycle.

For water service piping, cement or concrete joints shall be ________________.

Where potable water pumps are installed in basements, such pumps shall be mounted on a block or shelf not less than __________ inches above the basement floor.

Soldered joints of copper water supply piping shall be made with ______ - ______ solders and fluxes.

Existing metallic water service piping used for electrical grounding shall not be replaced with ____________ pipe or tubing until other approved means of grounding is provided.

The minimum diameter of water service pipe shall be ____________ inch.

Lavatories shall have a minimum __________ - inch water supply pipe.

__________ valves shall be installed on the water supply pipe to each appliance or mechanical equipment.

The hot water supply to any fixture shall be installed on the _______ - hand side of the fixture.

Freeze proof yard hydrant that drains the riser into the ground is considered to have a ________ - _____ - __________ valve below grade.

Where water pressure within a building exceeds __________ psi static, an approved water pressure-reducing valve with a strainer shall be installed to reduce pressure to not greater than _______ psi static.

A water-hammer arrestor shall be installed where __________ - __________ valves are utilized.

Non potable water outlets, such as hose connections, open-ended pipes and faucets, shall be identified with signage that reads as follows: “Non potable water is utilized for (application name). CAUTION: ______ __________ - _____ _____ _______.”

What color shall be used to identify piping in nonpotable water distribution systems?

Water service pipe and the building sewer shall be horizontally separated by not less than ______ feet of undisturbed or compacted earth.

Unless otherwise provided in this code, __________ water shall be supplied to all plumbing fixtures.

__________ - open valves shall be installed on the water supply pipe to every water heater.

Backflow preventers shall not be located in areas subject to ______________.

Water service pipe or tubing, installed underground and outside of the structure, shall have a working pressure rating of not less than ___________ psi.

For potable water outlets with effective openings greater than 1 inch, the minimum air gap close to a wall shall be _______ times the diameter of the effective opening.

Pipe, pipe fittings, joints, valves, faucets and fixture fittings supplying water for drinking or cooking purposes shall have a weighted average lead content of _______ percent or less.

Hot water distribution pipe and tubing shall have a pressure rating of not less than ________ psi at 180 degrees Fahrenheit.