Harvested rainwater should not be used for:

What the minimum and maximum depth of cover for a cold water supply pipe?

What size of pipe is normally used to feed an indirect cold water system from the cold water storage cistern?

What type of backflow into the cold mains supply is caused by the expansion of water?

The backflow prevention method used for the appliance in the picture is a:

What is the name of component with the empty arrow of this BS1212 part 2 float operated valve?

If a direct cold supply water system is to be used, what must the property have?

Which of the following should be used where cold water pipes pass through a wall?

What hand tool is shown in the picture?

What is the name of this measuring device?

On a cold water storage cistern, where should the outlet be positioned?

What must be used to reinforce the fitting of a float operated valve on a plastic storage cistern?

In which of the following types of structure is it possible to embed cold water pipes in chases?

Which of the following must be installed on the cold water supply pipe to a WC cistern?

It is necessary to insulate a cold water storage cistern installed in a heated space to prevent:

What documentation would contain maintenance information for a water softener?

What steps should be taken to check the operation of a double check valve on a cold water supply system as part of a periodic maintenance inspection?

During a routine inspection a plastic cold water storage cistern is found to be supported on two ceiling joists. What remedial action is needed?

Which of the following items of information is required on a maintenance record for terminal fittings on cold water systems?

A working method which can help to save time during work to renew cold water systems pipework and draw-off fittings is:

Which document should be given to the plumber to enable them to identify what part of a cold water system is to be decommissioned?

Which two components are used to temporarily decommission sections of cold water installations?

Which of the following actions must be undertaken first when permanently decommissioning cold water supply pipework?

Prior to filling a cold water system with water for testing, checks should be made to ensure that:

Which of the following steps must be taken prior to the initial filling of a cold water system for the purpose of leak testing?

Which type of pipe material should be tested for soundness at 1.5 times the normal operating pressure without loss of pressure?

Cold water systems must be flushed with cold water following the completion of:

What action should be taken when pipework support bracketing is defective?

The cover of a cold water storage cistern must provide adequate protection against:

What is the component shown ?

What component(s) makes connecting water supply pipes to pedestal wash basins easier?

A BS1212 type 2 float operated valve in a cold water storage cistern is causing the warning pipe to continually overflow. Which of the following remedial work tasks is required?

If the water mixes in the body of a mixer tap, what must be provided to protect the cold supply from risk of backflow?

Which water treatment process involves adding a chemical coagulant to bind particles together and remove colour, turbidity, and algae?

What is the clipping distance for 22mm copper pipe?

What is the clipping distance for 15mm copper pipe?

What is the maximum depth allowed for a notch in a joist that is 200mm deep?

According to Building Regulations Part A, what is the maximum depth a joist can be notched to?

According to Building Regulations Part A, To work out the maximum diameter of a hole you can drill in the joist you divide the depth of the joist by what measurement ?