Technician A says that tubeless tires are much easier to repair. Technician B says that tube tires are much easier to repair than the tubeless tires. Who is correct? Select one:

The hot curing process is also known as ________. Select one:

With ________, the tire tread moves up and down. Select one:

What would you spray around a tire valve stem and core to detect air leaks? Select one:

When tires are replaced or rotated, the TPMS must ________ the tire position. Select one:

________ provide the clamping force needed to hold the wheel against the hub. Select one:

All wheel nuts must be tightened to the correct torque and in the proper ________. Select one:

With little or no preload, the force of the hydrodynamic wedge is ________. Select one:

What is a leading cause of premature wheel seal failures? Select one:

A stud-piloted wheel's inner nut has a ________. Select one:

Technician A says it's important to inspect wheels and rims for lateral and radial runout conditions while checking vibration-related complaints. Technician B says that before checking for runout, it is important to first check for problems in the hub, such as loose wheel bearings. Who is correct? Select one:

Tire inflation pressures are always measured when ________. Select one:

Wide-base tires are large tires with a low ________. Select one:

The hot curing process is also known as ________. Select one:

When tires are replaced or rotated, the TPMS must ________ the tire position. Select one:

What type of tire tread is best for muddy, off road surfaces? Select one:

Heavy pulling of a vehicle to either the left or the right while the customer is driving may be caused by which of the following? Select one:

Where are pusher axles mounted? Select one:

When turning to the right, the right side steer tire tilts ________. Select one:

A typical drag links ________ length is critical to maintain the same number or turns from center to the steering stops. Select one:

When the vehicle rolls down the road, ________. Select one.

Which of the following is NOT a type of wheel alignment method? Select one.

Tire life and ________ are improved by maintaining a correct wheel alignment. Select one.

Technician A says today's trucks and buses exclusively use power-steering gears rather than manual gears that have no power assist. Technician B says it is not possible to add an air or hydraulic cylinder to the steering linkage of a conventional worm-gear steering box. Who is correct? Select one.

What ensures the correct phasing of the steering column U-joints when being reassembled after servicing? Select one.

Which of these best describes steering ratio? Select one.

Two critical components of the hydraulic control mechanism of all power steering gears are the rotary valve and the ________. Select one.

The ________ design of tie-rod ends and tie-rod centers enables sharp turning radiuses without interference. Select one.

Which of the following is a possible cause of binding? Select one.

What force would be trying to stretch a rail apart? Select one.

Which of the following is a flat, steel plate reinforcement bolted usually inside and sometimes outside the frame rail? Select one.

What type of mounting is the recommended method of attaching flexible bodies to a ladder-type frame? Select one.

Damaged bolts or rivets are to be replaced with ________ attaching hardware when a frame has been straightened. Select one.

Which of these welding processes cannot be used when repairing cracked frame rails? Select one.

Technician A says that frame misalignment might result in rapid tire wear. Technician B says when the frame is misaligned, driver fatigue will increase as the operator has to fight the steering wheel to keep the vehicle in a straight line. Who is correct? Select one.