Gas Safety Regulations C&I l3p3/4

A separate emergency control valve is required on single cylinder installations...?

• True

• False

The Gas Safety (Installation and Use) Regulations 1998 Code of Practice is approved by...?

• The Health and Safety Executive

• The Local Council

• British Standards

• The Institute of Gas Engineers and Managers (IGEM)

The gas installer and the responsible person for a premise have duties to permanently identify pipework as carrying natural gas. This requirement does NOT apply to which type of premises...?

• Industrial gas installations

• Commercial installations

• Domestic installations

• Shops and offices

Which one of the following is NOT defined as 'a supplier of gas'...?

• A landlord

• A person supplying gas to a premises through a primary meter

• A person who provides a supply of gas to a consumer by means of the filling or re-filling of a storage container

• A person who provides gas in a refillable cylinder

According to The Gas Safety (Installation and Use) Regulations 1998, any reference to an 'appropriate standard' is a reference to any of the following which are current at the time of the work activity:

• A British Standard

• A relevant standard or code of practice of a national standards body of any n member state of the European Union (EU)

• Traditional procedures of manufacture of a member state of the EU where these are the subject of a written technical description sufficiently detailed to permit assessment of the goods or materials for the use specified

• All the above

On what date did the Gas Safety (Installation and Use) Regulations 1998 come into force?

• 1st Jan 1998

• 31st July 1998

• 1st October 1998

• 31st October 1998

The Gas Safety (Installation and Use) Regulations 1998 apply to 'gas fittings' used in...?

• Mines, quarries, agricultural premises, training and assessment establishments

• Self propelled vehicles, sea going ships and hovercraft

• Premises used for the treatment of sewage

• Domestic premises supplied by a gas distribution main or storage vessel

Which of the following statements is INCORRECT when an LPG installation supplied by a vessel requires a regulator installing or adjusting

• Only the supplier can adjust and reseal the regulator

• Immediately after installation or adjustment the regulator is adequately sealed so as to prevent its setting from being interfered with without breaking of the seal.

• LPG Regulators are factory set and operatives are not allowed to break the seal, or adjust the regulator

• A person authorised by the supplier to act on his behalf can adjust and reseal the regulator

Gas fittings shall be protected when they are exposed to environments containing...?

• Salt spray or corrosive chemicals

• Soot

• Dampness

• All of the above

Which of the following statements are true in relation to existing gas fittings

• No person shall make any alteration to any premises if the alteration could affect the continued safe use of any gas fitting in the premises.

• No person shall do anything to any fitting, flue or means of ventilation which would cause the fittings etc. to constitute a danger.

• In relation to a place of work, an employer or self employed person shall ensure that as far as is reasonably practicable no alterations to fittings or premises shall be such that a they would constitute a danger

• All of the above