NEW
Font size
WorksheetsTLE10 - Pre-test
Total questions: 18
Worksheet time: 6mins
This fitting is used to connect the FMT to any type of electrical box.
L-shaped
Coupling
FMT Connector
Connector
What are the two units that can be measured using multimeter?
Resistance and microfarad
AC voltage, and resistance
Ohm and Volt
AC voltage and DC voltage
It is the minimum length of conduit in a single roll.
30ft
40ft
50ft
60ft
In measuring the amount of AC voltage in convenience outlet, where do you place the black and red test probes?
Red test probe is for positive part of convenience outlet while black is for negative.
Black test probe is for positive part of convenience outlet while red is for negative.
Black test probe should be on left socket of outlet while red is on right socket because of polarity.
You can place it either left or right socket because AC voltage has no polarity.
What is the last thing to do in measuring AC voltage using an analog multimeter?
Look at the pointer of LED display panel.
Check the measurement on the LED display panel of multimeter.
Read measurement on the scale of multimeter.
Select the require range in AC volts range.
It is the maximum number of conductors for a trade size no. 12 AWG. in a ½ inch diameter size conduit.
7
8
9
10
FMT means _______________.
Flexible metal tube
Flexible metallic tube
Fittings for metal tube
Flat metallic tube
What is the proper bend that can be used if you want to bridge the rigid steel conduit over obstacles such as existing plumbing pipe?
Three-point saddle bend
Back to back bend
Stub-up bend
90-degree elbow
This bend is used to run the conduit into electrical box.
Back to back bend
90-degree stub-up
Three-point saddle bend
Offset
__________ is used if you want to fit conduit between two parallel surfaces such as two walls or joists
30-degree offset
45-degree offset
Back to back bend
90-degree stub-up bend
An electrical equipment that is used to bend the rigid steel conduit.
Copper tube bender
Hickey tube bender
Steel bender
Metal bender
Graduation Scale for Voltage:
X10V = __________
0.2 volts per line
5 volts per line
1 volt per line
20 volts per line
Graduation Scale for Resistance:
X1 Ohms (2 ohms to 10 ohms) = __________
0.2 ohms per line
1 ohm per line
0.5 ohms per line
2 ohms per line
The setting of multimeter is in X10 ohms. What is the reading of resistance that is shown on the scale?
15 ohms
15.5 ohms
16 ohms
16.5 ohms
It is also known as line wire. It carries electricity from source going to the load.
Hot wire
Neutral wire
Return wire
Main wire
What do you call a wire of fan motor with highest resistance?
Auxilliary
Common
High fan speed
Low fan speed
What do you call a wire of fan motor with lowest resistance?
Auxilliary
Common
High fan speed
Low fan speed
What do you call a wire of fan motor with second to the highest resistance?
Auxiliary
Common
Low fan speed
Medium fan speed
