These are metals with metals other than iron as their main constituent.

The following are physical properties of metals, EXCEPT _____.

A physical property where light interacts with the surface of a crystal, rock, or mineral.

A physical property that produces different sensations on the eye as a result of the way the object reflects or emits light.

Refer to the figure shown. Samples of aluminum, nickel, silver, and steel are of the same shape and dimensions. Assuming these samples as cubes, which of these may have the greatest mass?

Refer to the figure shown. Which metal might melt when subjected to a temperature of 300 deg. C?

Refer to the figure shown. Which metal is considered best in conducting heat?

It is the ability of a material to resist the externally applied forces without breaking or yielding.

It is the ability of a material to resist deformation under stress, applying the modulus of elasticity as its limit.

It is the ability of a material that makes it regain its original shape when external forces are removed.

It is the ability of a material that retains the deformation produced under load permanently.

It is the ability of a material that makes it turn into wire when a tensile force is applied to it.

It is the ability of a material that easily breaks when subjected to tensile loads.

A special case of ductility that permits a material to be rolled or hammered into thin sheets.

Property of a material that can resist fracture due to high impact loads like hammer blows.

Property of a material that absorbs energy and resists shock and impact loads.

When a part is subjected to constant stress at a high temperature for a long period of time, it will undergo a slow and permanent deformation called _______.

When a material is subjected to repeated stresses, it fails at stresses below the yield point stresses. Such type of failure of a material is known as ______.

A property of material described by its resistance to wear, scratching, deformation and machinability.

A material chemically made from 64% Fe and 36% Ni.

Which of the following is the chemical composition of constantan?

A material made from 90% copper and 10% nickel is called ____.

__________ is a gradual chemical or electrochemical attack on a metal by its surrounding medium.

An iron ore with 70% iron content is called ______.

An alloy of iron and about 1.7 to 4.5 percent carbon is called ____.

This is considered the purest iron, with at least 99.5 to 99.9% iron composition.

An alloy of iron and carbon whose C should not exceed its 1.5% limit.

A type of steel, when correctly heat treated and finished, resists oxidation and corrosive attack from most corrosive media.

A widely used non-ferrous metal typically found in electric cables and wires for electric machinery and appliances.

A material that is so soft and typically used in making solders, as lining for acid tanks, cisterns, water pipes, and as coating for electrical cables.

A/An ____ is an ordered array of points describing the arrangement of particles that form a crystal.

The space left unoccupied by atom/particle in a simple cubic unit cell is about ____.

The crystal is made up of covalently bonded atoms, it can be described as ______ lattice.

It is the number of nearest neighbors in a lattice.

It is the fraction of volume occupied by atoms in a cell.

These are materials generally made from long, repeating chains of molecules.

Substances with two or more components mixed with metal.

It is used to determine the hardness of a material by measuring the depth of penetration of an indenter on the material being tested.

Which of the following must be present for rusting to take place?